WirelessG
MemberGot rid of the matchlight.
Hi guys. 1st Post. I've searched and searched, trying to find out how to wire a PID to run a fan for my smoker. I have the PID powered, have set the target temp, and the probe is reading ambient temperature. As far as wiring the SSR and fan, I am at a a loss. I do not plan on having a switch, just a male end of a power chord to plug in. I've attached two pdfs. "PID Diagram" shows how the power cord, PID, and probe are wired along with my half-baked guess at the fan and the SSR. "PID Components is the same thing, but with the wiring removed in case someone wanted to mark up a clean version. I am terrible - terrible with electricity. Any help would be very appreciated. Below are hyperlinks to each of the competences in case that is of any interest. The fan is rated for 35CFM with a high/medium/low. The operating specs on the fan are 3-7V DC, 0.2A, 1.05W.
PID
SSR
TC
FAN
PID
SSR
TC
FAN