GrillsGoneWild
is one Smokin' Farker
- Joined
- Aug 30, 2010
- Location
- Rockwall, TX
I needed to cook up a couple of briskets and pork butts this weekend, so I dropped inn Restaurant Depot over lunch time on Friday. I was in a hurry and was only looking at the size of the packers since I've never had a problem with them trimmed out before. Well, I cut open the package tonight to inject it and it looks like RD had hired Ray Charles to butcher for them. The fat cap stopped on only the flat and didn't cover the whole flat. As you can see by the pic below the fat cap isn't even there on the right side. That's not the side of the brisket, its the bottom where the fat cap should be. This was on a 10 pounder and there was thick hard fat on both sides of the point that needed to be trimmed. The 15 pounder I also picked up had some butcher problems to it, but at least the fat cap was all the way across the flat. I guess I'll be wrapping early on the smaller one so it doesn't get dried out. Especially since I'm going to kick up the heat a little more than I normally do (275 versus 225). In my DPP Fat 50 the temp is very even so I usually go fat cap up so I don't need it there to block heat, I just like having that melt down into the meat. Well see how it goes tomorrow.