The Yorkshireman
Found some matches.
- Joined
- Jun 4, 2017
- Location
- Leeds
Hello
I've tried posting this in the UDS thread but had no reply. I'm currently building my first UDS. I've gone for the three intake design with one ball valve (the valve being on one of the three intakes). I've got two 1/2 inch unions from work and one 15mm ball valve, I believe 15mm is 1/2inch. Internal diameter. I've realised everyone is using 3/4 inch now I've gone and drilled the holes! Will I have issue with getting up to temperature using this smaller size or will I be ok using 1/2inch instead of 3/4?
Thank you in advance.
I've tried posting this in the UDS thread but had no reply. I'm currently building my first UDS. I've gone for the three intake design with one ball valve (the valve being on one of the three intakes). I've got two 1/2 inch unions from work and one 15mm ball valve, I believe 15mm is 1/2inch. Internal diameter. I've realised everyone is using 3/4 inch now I've gone and drilled the holes! Will I have issue with getting up to temperature using this smaller size or will I be ok using 1/2inch instead of 3/4?
Thank you in advance.