1FUNVET
Babbling Farker
Looks like the guys in our cylinder repair shop will be scrapping a hydraulic cylinder. Barrel is 18" diameter x 48" long. Thickness on this bad boy is 3/4". Is this too thick to use to make an off set smoker? :?::?:
Only problem would be moving it... Oh, and trying to cut it... and trying to weld it...
Other than that, go for it!
Only problem would be moving it... Oh, and trying to cut it... and trying to weld it...
quote]
Welding and cutting would be easy, even with oxy/acetylene, although flux core or sticks would be quicker to weld.
Moving, a whole diffrent problem, unless your drive is 12" concrete, LOL.
Jeff
Looks like the guys in our cylinder repair shop will be scrapping a hydraulic cylinder. Barrel is 18" diameter x 48" long. Thickness on this bad boy is 3/4". Is this too thick to use to make an off set smoker? :?::?:
Looks like the guys in our cylinder repair shop will be scrapping a hydraulic cylinder. Barrel is 18" diameter x 48" long. Thickness on this bad boy is 3/4". Is this too thick to use to make an off set smoker? :?::?:
The weight of that bad boy will be approximately 550 lbs before firebox and accessories.