I have a few that I am holding for the store. I can still take care of you. Send me a PMSweet. Thx Steve. Will keep an eye out for when web orders are being accepted again.
What are using as a reference?I sure wish the 732 offered calibration - mine is several degrees off and quite frankly it pis$es me off that I can't correct it....
What are using as a reference?
Thats the kind of thing I was afraid of by just letting it hang!Or stressing out the cables.
Any one have a good set-up for the WSM ?
i've had mine feb. use mine at least weekly first pit probe went bad right away. they took care of it quickly. since then no problems as of yet cross my fingers
Are you testing in boiling water? If you are what is the boiling temp at your elevation?2 Thermapens and a Guru probe that are within 1 degree of each other... The ET732 reads a consistent 6 degrees lower... At least it's consistent :tsk:
Any thoughts/help would be appreciated. Thx.
Are you testing in boiling water? If you are what is the boiling temp at your elevation?
If it is off 6 degrees call Maverick. I believe the unit is supposed to be +-2 degrees.Yes, I'm at 500 ft with a local barometric pressure of 1012 = 211.9 degrees (corrected).
You are welcome. I am glad you got it so quickly. :-DSteve,
Thanks for the fast shipping! Very nice!!!
How do I know if the receiver is picking up the temps from the correct probe ends?
You are welcome. I am glad you got it so quickly. :-D
Dont worry about using two units. Set up one first then set up the second and you will fine.