What's new
THE BBQ BRETHREN FORUMS

Welcome to The BBQ Brethren Community. Register a free account today to become a member and see all our content. Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Horizontal & Offset Drum Smokers

I used the same stainless stuff in the UDS and had to make larger holes.
 
Norcoredneck said:
OK anyone want to dare me to make an horizontal woodburning drum smoker?:twisted:
Click to expand...
That's pretty much what I've had in mind since returning from Lockhart a few weeks ago:
• Needs to burn wood
• Needs to use indirect heat
• Needs a bit more room/easier access for more meat than the UUDS™
• Needs to use up the three barrels I have behind the garage

Just been gathering ideas. Seen a couple good ones here so far...
 
Lighting a horizontal drum

How do you guys start your horizontal drum for grilling?
Do you throw only hot coals out of the chimney starter in it or do you lay a bed of hot coals on the grid and then cold coals over it?
And to get this thing nice n hot do you have the chimney open,half open or almost closed?
 
Whats a Redneck know about barrels?? Doubt you could do it!!


LOL- is that what you're looking for?

I might have to try one- I've got the drums, a bunch of angle iron, some expanded and a welder. I just enjoy my UDS so much I dont think I could be any happier.
 
1st post. Awesome builds.
I was thinking about upgrading to something more expensive, now, i think i can build what i need for a heck of a lot cheaper...a little intimidating though, who would I blame when it doesnt work correctly?
 
Ideas

I've got some mini barrels that I wanna convert into horizontal drum smokers but they have an open top.
What should/can I do,weld the lid to the drum or are there other ideas/concepts how I can solve this?
 
Phubar said:
I've got some mini barrels that I wanna convert into horizontal drum smokers but they have an open top.
What should/can I do,weld the lid to the drum or are there other ideas/concepts how I can solve this?
Click to expand...
Just re-read this... I would weld the lid on top. Then cut it horizontally. If you're not much of a welder this will be good practice.
 
You must log in or register to reply here.

Similar threads

S
MY New Horizontal Offset
2
Replies
36
Views
3K
Mikhail
Mikhail
E
why the popularity of the horizontal smoker
2 3
Replies
50
Views
3K
el luchador
E
F
Massive Ugly Drum
2
Replies
38
Views
12K
Firerunner
F
C
In the market for an offset smoker
2 3
Replies
58
Views
4K
Casey3115
C
D
Ugly Drum Smoker (UDS) Build from Old Town Smokers
Replies
10
Views
933
lastmajordude
lastmajordude
Back
Top