Our Homepage Donation to Forum Overhead Smoke Signals Magazine Welocme Merchandise Associations Purchase Subscription Amazon Affiliate
Go Back   The BBQ BRETHREN FORUMS. > Discussion Area > Q-talk


Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, equipment and outdoor cookin' . ** Other cooking techniques are welcomed for when your cookin' in the kitchen. Post your hints, tips, tricks & techniques, success, failures, but stay on topic and watch for that hijacking.

Thread Tools
Old 12-22-2011, 02:15 PM   #1
Full Fledged Farker
Join Date: 05-17-11
Location: Baltimore, Maryland
Default A few turkey fryer tips?

I've never used this propane fueled deep fryer before and I have a few questions. If anyone wants to chime in with tips please do so. This is a standard Brinkman turkey fryer with big pot and propane attachment. I plan on doing two turkeys on Christmas day.

1. Do you prefer to use the large basket or the turkey stand (which goes through the cavity) to hold it? My set came with both.

2. My instructions say to adjust the flame until it is a blue flame with minimal yellow. Well that's impossible. I adjusted both the gas pressure (from the tank) and the air intake and its either yellow with a little bit of blue at the base, or totally yellow. Is a yellow flame ok? If so, I assume it shouldn't be roaring up the sides of the pot? I assume I need a slow controlled flame which stays below the pot. Last night's test resulted in water getting to boiling in about 20-25 min with a small flame not going up the sides of the pot.

3. Also the pot it came with turned pretty nasty black on the bottom and the sides just from this first 25 min test trial with boiling water. It flaked off with a paper towel. Kinda odd?

Any advice is greatly appreciated. I'm a charcoal guy so this newfangled big gas tank is sort of freaking me out.


Weber Performer, 18.5" WSM, UDS.
grilling24x7 is offline   Reply With Quote

Old 12-22-2011, 02:24 PM   #2
On the road to being a farker

Join Date: 09-06-11
Location: D/FW, Texas

1. I use the turkey stand. I have a basket for frying fish/smaller items and for boiling crawfish.

2. No, the fire should not be roaring so big as to come up the sides of the pot. I'm not even sure mine will get that high. I usually have a mix of a blue/yellow flame. I wouldn't worry about that as much as just getting it to stay relatively constant. Build a small wind screen if needed, the wind can really screw with the fire.

3. The bottom of the pot will turn nasty, it's just part of cooking over an open flame.

Make sure that you measure the level of the oil needed with water before you put it in. I usually subtract about an inch-inch and a half because the oil will expand some. Big grease fires aren't fun, so just be careful and enjoy it. Fried turkey is now a staple at my house for the holidays.
-Lazy Bones BBQ
-Custom competition trailer with an offset and a cabinet. And a kettle or two.
Lazybones is offline   Reply With Quote

Old 12-22-2011, 02:33 PM   #3
Full Fledged Farker
Join Date: 11-22-11
Location: Waconia, MN

Don't do it on your wood deck! Unless you're special you WILL have some oil spillage and a good possibility for a little fire. When you lower the turkey into the oil do it SLOWLY and wear a heavy glove like a welders glove. Don't wear sandals or shorts and when the oil starts boiling up like crazy don't just drop the turkey into the fryer and run away, go slow and you can keep it under control.
__________________ - My Backwoods Pro Clone
TTNuge is offline   Reply With Quote

Old 12-22-2011, 02:38 PM   #4
Full Fledged Farker
stubshaft's Avatar
Join Date: 12-05-11
Location: State of Confusion - Middle of the Pacific

I agree with Lazybones. One other thing I would like to add is to wear heatproof gloves when putting the turkey in, lower it slowly (as it will hiss and spit) keep an eye on the foaming. Since it is always windy where I live I usually fashion a windscreen around the base of the fryer with some foil.

BTW - I would adjust the flame so that it has some blue showing.
If God didn't want man to eat animals. He wouldn't have made them out of MEAT!
stubshaft is offline   Reply With Quote

Old 12-22-2011, 02:39 PM   #5
is One Chatty Farker
Join Date: 07-05-09
Location: Aurora, Colo.

Don't cook it in your Garage.

Set up at least 10 feet away from your house and anything else that can burn....such
as a patio or deck or anything flammable.

Have the proper kind of Fire Extinguisher close by....if there is a fire....don't throw
water on it, or use your garden hose; that will turn a small fire into a BIG fire.

Keep children and pets far away from the cooker.

Allow the Turkey to drain really well before submerging it into the oil; if necessary
use some paper towels to pat the Turkey dry on the outside and inside to remove
as much moisture/water as possible.
Grillman is offline   Reply With Quote

Old 12-22-2011, 02:53 PM   #6
Got Wood.
Join Date: 11-09-11
Location: Mobile.Al.

Make sure it completely thawed!!
PacoG2 is offline   Reply With Quote

Old 12-22-2011, 02:53 PM   #7
Got Wood.
Join Date: 12-18-11
Location: Tempe, AZ

It sounds like the regulator on your gas connection is poorly made. This happened when a friend of mine bought a fairly cheap fryer from the NEX. He had to go the a hardware store and build himself a custom gas connection to make it work.

If your regulator doesn't give you good control, you run the risk of overheating your grease. Grease that gets even 30 degrees too hot before you realize it turns into a difficult situation to manage. That stuff holds tons of heat, and won't cool down for a pretty long time.

Chris' fryer started spattering all over his patio and wouldn't stop for a half hour. Make sure you can get the right kind of flame before you start a serious fry :)
zakaluka is offline   Reply With Quote

Old 12-22-2011, 02:53 PM   #8
Babbling Farker
Join Date: 02-02-08
Location: Westfield,Ma.

Most important do not let children or for that matter anyone near the cooking area. Have one or more fire extinguishers available and manned at all times. Lower your dried turkey very very slow. And do not leave it unattended even for seconds. Plan ever move and do a dry run on how your going to do it. As in having all your gloves,pans ect. ready right down to who in going to open the door for you after it's cooked. Just because it's out of the fryer it's still very hot. One slip could leave you or others with injuries. There's isn't anything we do here worth getting hurt for. Good luck.
Skidder is offline   Reply With Quote

Old 12-22-2011, 03:08 PM   #9
is One Chatty Farker
Join Date: 08-23-10
Location: Austin Texas
Name/Nickname : D

Do it away from your house and lower the bird in SLOWLY real slow.Use the turkey stand that works best. Keep temps at 350 I usually start mine at 375 as the temp will drop ounce you put the bird in. Also do 3 1/2 minutes a pound and you will have the color you and me know your looking for some do 3 min a pound and five minutes finishing up after its all done. Don't worry you'll be good I'm not a big gas man myself and don't really play with weed burners so I know how you feel. Good luck send us PRON!

Sent from my SGH-T959 using Tapatalk
Pitmaker Magnum Snipper * UDS* Copper Kettle
AustinKnight is offline   Reply With Quote

Old 12-22-2011, 03:34 PM   #10
On the road to being a farker

Join Date: 09-12-11
Location: Blaine, MN

Yes, it's VERY important to carefully measure the amout of oil you use. I usually only fry birds that are less than 15 lbs, usually I try to find them in the 12-13 lb range.

Make sure you remove the gravy and giblet bags before cooking!

Put bird in empty pot (on your turkey stand) and fill with water till it barely covers the bird. Remove the bird and mark where the water line is. I used a screwdriver or punch to mark the line on the inside of pot.

Empty water from pot and dry off bird completely.

Fill pot with oil (I usually use peanut or regular veggy oil) to your mark.

Heat oil to 325-350F and SLOWLY, VERY SLOWLY lower into oil. I cant stress enough the importance of going slow.

3 1/2 mins a pound, and add 5 mins (for oil to recover from cold bird)

Make sure you let the bird rest 20-30 mins before carving or shredding.

There are LOTS of good injection mixes out there. Inject before frying. I try to avoid puncturing the skin.

putting a rub on the outside sometimes leaves you with a ver blackend bird, I dont do it. Also try to not let the temp get over 350 at anytime.
Chargriller Pro w/SFB
Weber kettle(s)
Weber gasser
22" WSM
18" WSM
Lyfe Tyme stickburner

Last edited by mnmikew; 12-22-2011 at 03:44 PM.. Reason: added inject info
mnmikew is offline   Reply With Quote

Old 12-22-2011, 03:52 PM   #11
Full Fledged Farker
Join Date: 05-17-11
Location: Baltimore, Maryland

Fantastic comments everyone! I'm still listening if anyone else has anything to say.

I think I should be good to go. Everything you guys said is in agreement with what I've learned from various YouTube videos. I trust you guys so much more, however!

Weber Performer, 18.5" WSM, UDS.
grilling24x7 is offline   Reply With Quote

Old 12-22-2011, 04:46 PM   #12
Jason TQ
somebody shut me the fark up.

Jason TQ's Avatar
Join Date: 01-10-11
Location: Lawrenceville, GA

Don't be too drunk when you fry . Looking forward to frying on Xmas eve.
I didn't choose D-Canoe life..........
SF 24x36 On Order
3 Hunsaker Drums
Big Green Egg XL
Pitboss Copperhead 5
Pitboss Whiskey Still
Pitboss Tailgater
Jason TQ is online now   Reply With Quote

Old 12-22-2011, 05:00 PM   #13
Pyle's BBQ
Babbling Farker
Pyle's BBQ's Avatar
Join Date: 10-25-06
Location: Madrid, IA

Here is a good video to watch. Take what you want from it.

Good Eats - Fry Turkey Fry [Full - HD Quality] - YouTube
Team: Pyle's BBQ

Yoder YS640; Good-One "Trail Boss" 60T; Weber Kettle rotisserie ring; Big A$$ Rotisserie; New Braunfels offset smoker; Weber Smokey Mountain; Backyard Bombers BBQ HJM

Μολν λαβέ
Pyle's BBQ is offline   Reply With Quote

Old 12-22-2011, 05:43 PM   #14
Knows what a fatty is.
Join Date: 12-30-10
Location: Cloud 9

Originally Posted by mnmikew View Post
Put bird in empty pot (on your turkey stand) and fill with water till it barely covers the bird. Remove the bird and mark where the water line is. I used a screwdriver or punch to mark the line on the inside of pot.
This should have asteriks all around it!!!!!! This step will keep you from being on a Smokey the Bear commercial. Former boss didn't do that and had a nice little fire going when he put his turkey in and it went over the sides. I didn't like him much so after finding out nothing burned down I laughed (on the inside)
sullysQ is offline   Reply With Quote

Thanks from:--->
Old 12-22-2011, 05:57 PM   #15
Full Fledged Farker
Join Date: 05-17-11
Location: Baltimore, Maryland

Another question: I have a 3 gallon box of frying oil blend. 3 gallons enough?
Weber Performer, 18.5" WSM, UDS.
grilling24x7 is offline   Reply With Quote


fryer, gas, turkey

Similar Threads
Thread Thread Starter Forum Replies Last Post
if you have a turkey fryer, then you need to try this! Big slick Q-talk 25 07-08-2013 11:00 AM
turkey fryer Garth57 Q-talk 2 06-21-2010 08:39 PM
turkey fryer motley que Q-talk 12 02-06-2007 07:24 AM
Tuesday, 9:22 PM and the turkey fryer is going chad Q-talk 20 12-16-2004 01:59 PM

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Forum Custom Search: Enter your Search text below. GOOGLE will search ONLY the BBQ Brethren Forum.
Custom search MAY not work(no display box) in some configurations of Internet Explorer. Please use compliant version of Firefox or Chrome.

All times are GMT -5. The time now is 01:36 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.
no new posts