What a mess

Camille Eonich

Full Fledged Farker
Joined
Aug 7, 2008
Location
Granite...
The handle on my chimney starter melted and ruined not only the starter but the small Weber kettle that I had it sitting on. Anyone else managed to melt a handle?
 

Attachments

  • ChimneyStarter.jpg
    ChimneyStarter.jpg
    32.2 KB · Views: 604
The handle on my chimney starter melted and ruined not only the starter but the small Weber kettle that I had it sitting on. Anyone else managed to melt a handle?



Never! WOW! How did you manage to do that? On the bright side it sounds like someone deserves a new grill :)
 
Never melted one, but have gotten them way too hot. I have learned not to sit them on the charcoal grate to start them. The sides of the kettle holds too much heat in on the handle. You can probably take a heat gun and a scraper to your grill and clean it up, then just buy a new handle from weber.
 
Congrats on the new Rec Tec. Now if I could only get away with something like that to get a cooking upgrade.
 
Not sure I should admit I've done it to that level and got one to start sagging. I upgraded to a Weber Performer with the propane starter and just stack the briquettes
 
I have melted a handle. Chimney still works, though. It (along with a shirt with a huge flame-caused hole) is a reminder that fire can be your friend or your enemy.
 
I lit up a chimney of lump charcoal and after five minutes it was sparking like crazy. I live in Southern California where wildfires start very easily. I also live in a condo with three neighbors attached to our unit.

My solution was to put the kettle lid over the chimney until it stopped sparking so much. When I looked at it a few minutes later, half the handle had melted. The chimney still works but I'm done with lump until I have my own house.
 
Never melted a handle, but last summer i placed my chimney on the concrete driveway and lit it.. Big mistake, the concrete superheated, and as i was picking the chimney up to bring to the grill, the concrete exploded, luckily i didn't get any in the face, but got peppered in the leg. That was not fun.
 
Never melted a handle, but last summer i placed my chimney on the concrete driveway and lit it.. Big mistake, the concrete superheated, and as i was picking the chimney up to bring to the grill, the concrete exploded, luckily i didn't get any in the face, but got peppered in the leg. That was not fun.


Oh crap! Did you? LOL I have heard of blocks under Kamados exploding when the bottom was flat on the blocks.
 
Never melted one, but have gotten them way too hot. I have learned not to sit them on the charcoal grate to start them. The sides of the kettle holds too much heat in on the handle. You can probably take a heat gun and a scraper to your grill and clean it up, then just buy a new handle from weber.

MMMMM interesting. I do think you make a good point, particularly with a small Weber like cooker.
 
Never melted a handle, but last summer i placed my chimney on the concrete driveway and lit it.. Big mistake, the concrete superheated, and as i was picking the chimney up to bring to the grill, the concrete exploded, luckily i didn't get any in the face, but got peppered in the leg. That was not fun.

Did the same thing a couple years ago, luckily I wasn't right near it. I was inside the house and it sounded like someone shot a 22 right outside my door, scared the F outta me.


IMG_1080.jpg
 
Avoid exploding cement

I avoid the exploding cement by using a cheap oil catch pan. I got it a few years back for $5, and while it's rusted and warped in places, it keeps me from wrecking the patio:grin:
 
attachment.php

This was my ordeal a couple of years ago when I put my chimney on a flagstone. It exploded, sending coals in about a 6-8' spread, and notice how it warped the chimney.
 
I place my charcoal starter on the cooking grate of my Smokey Joe. Plenty of air and no overheating. Plus it is very portable.
 
Back
Top