Thank you!
|
Your the only redneck i know with a welder. :twisted:
Are you sure that holesaw isin't 1"? |
This might as well be made into a sticky right now.
|
Norco gave me these exact same plans. Cheep and easy, and the UDS holds temps all night long.
This is (IMO) the best method to build one of these amazing smokers. |
Quote:
|
Damn! I might as well go cut the toilet seat in half now!
|
I'm with Bubba.....please sticky this one ASAP. This is how I plan to build mine.
THANKS Norcoredneck!! Great job. I like the notes written on the barrel. You made it redneck proof! |
[quote=Bbq Bubba;656088]Your the only redneck i know with a welder. :twisted:
quote] I don't have A welder. You should know me by now, I have 5 :biggrin: |
Farking brilliant! Hey Pat, I am still up, can U believe it? :tongue:
|
Quote:
|
Very good tutorial.
Just curious, would you do the burnout before drilling the holes? |
Oooops, just wondering also why three sections not four?
I thought it might be tougher for a redneck to do that cipherin'. I think Jethro would have gone with four sections. lol |
I great looking build pictorial !
based on the genially accepted basic design ! Awesome work Pat! |
Quote:
Three points will always stay stable and not rock, even if off a titch bit! |
All times are GMT -5. The time now is 05:06 AM. |
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.