PDA

View Full Version : Question for an Arizona Brethren


NoviceBBQmovinUp
03-19-2010, 11:42 AM
I am looking for someone on here who either knows how and can weld my Expanded Metal to my grate. OR knows somone who can do it.

I tried the stanless steel zips, and i also tried wire tie and its just not doing it for me. I want someting more sturdy and i dont have a welder or welding skills.

Grillman
03-19-2010, 12:19 PM
When I had a smoker trailer, I drilled several holes in the angle iron,
so I could use stainless steel bolts to attach the expanded metal
grate to the angle iron...that way it was easier to clean under it or
replace it; if I waned too. Instead of welding it.

It depends on how yours is built; if you can do it this way or not.

NoviceBBQmovinUp
03-19-2010, 01:15 PM
When I had a smoker trailer, I drilled several holes in the angle iron,
so I could use stainless steel bolts to attach the expanded metal
grate to the angle iron...that way it was easier to clean under it or
replace it; if I waned too. Instead of welding it.

It depends on how yours is built; if you can do it this way or not.

Not sure what you are talking about...I am looking to do this (picture used from Norco's build thread)

Grillman
03-19-2010, 03:38 PM
I was thinking of something completely different.

If nobody here is able to help you...you might try someplace like a
custom trailer builder; or an independent car repair place.
They can probably weld something small like that for just
a few dollars. There are probably quite a few places like that
in the Phoenix area.

Smokin'Ron
03-19-2010, 03:55 PM
Can't help with the welding, I don't have a single weld in my UDS. I used Bolts to ring the Basket and used UBolts to attach it to the grate. You can see the Bolts on each side and the UBolts in the bottom, I put the Chain through the Ubolts.

May be a thought if you don't want to mess with welding.