PDA

View Full Version : BBQ Guru DX2


bunchde
09-24-2013, 11:26 AM
I'm looking to buy a DX2 and wonder if the 10cfm fan that comes standard is sufficient for a 22" WSM or if I should get the upgraded 25cfm fan?

ccarter
09-24-2013, 12:10 PM
I can run any of my smokers on the 10cfm fan: BWS Party, Large BGE, or 18.5" WSM... I can't imagine that you'd have a problem with the 22" WSM.

DriverWild
09-24-2013, 12:13 PM
10cm fan is plenty powerful for a UDS, WSM, BGE etc. If you get into bigger stick burners then you might need to upgrade.

BobM
09-24-2013, 12:35 PM
I have a CyberQ WiFi and the 10cfm fan is fine on my 22 1/2" WSM.

K80Shooter
09-24-2013, 01:21 PM
I have a XL-BGE and a 10cfm fan works great on it.

Cayman1
09-24-2013, 02:50 PM
10 cfm fan is fine for my WSM, in fact, I just ordered another Guru DX2 with the very same fan.

Big George's BBQ
09-24-2013, 02:55 PM
I believe the 25 will be way too strong

ssv3
09-24-2013, 02:59 PM
10cfm is way plenty for a WSM. I run the same fan at 1/3 with my cyberq wifi on my kamado to avoid overshooting temps. You'll be good.

dobdabomb
09-24-2013, 04:03 PM
I'm looking to buy a DX2 and wonder if the 10cfm fan that comes standard is sufficient for a 22" WSM or if I should get the upgraded 25cfm fan?


Lol just go ahead and get the 25cfm :mod:

Biged92
09-24-2013, 06:37 PM
Though I do not have a DigiQ, I do have a Stoker, and I use the 10 cfm fan with my 22.5" WSM. It works great. No need for the for the larger fan.

Fwismoker
09-24-2013, 09:42 PM
Heck i've used my PartyQ on my UDS and it works ok and that's only about 5 cfm.