View Full Version : USD build
ramthepork
11-08-2011, 02:11 PM
Hi, I'm pretty new to this blog, but I'm hoping to get an answer to a question. I am building a UDS and thinking about instaling the rotesserie ring from a weber 22 1/2, the problem is the ring is about 21 7/8 inches and the barrel about 23 inches. Is it possible to stretch the ring out enough so it will fit snugly inside the barrel and if so how do I go about it? Thanks in advance for any and all suggestions you give me!!
razrbakcrzy
11-08-2011, 02:27 PM
cut it in half and screw it in place...
bustem55
11-08-2011, 06:41 PM
cut it in half and screw it in place...
+ 1 on this response.
Cant wait to see it dad:thumb::clap2:
ramthepork
11-09-2011, 07:25 PM
thanks for the idea, sounds like it will work
RevZiLLa
11-09-2011, 07:34 PM
cut it in half and screw it in place...
Too simple, too smart! :thumb:
Skidder
11-09-2011, 07:59 PM
Thats funny cause mine fits pretty close.
http://i133.photobucket.com/albums/q64/Skidder1/Picture136-1.jpg
Skidder
11-09-2011, 08:02 PM
I just stuffed some woodstove gasket in the gap
vBulletin® v3.8.8, Copyright ©2000-2024, vBulletin Solutions, Inc.
Copyright ©2000-2024, The BBQ Brethren Inc. All Rights Reserved