Our Homepage Recipes Smoke Signals Magazine Welocme Merchandise Associations Purchase Subscription Brethren Banners(temp offline)
Go Back   The BBQ BRETHREN FORUMS. > Discussion Area > Q-talk


Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, Equipment and just outdoor cookin' in general, hints, tips, tricks & techniques, success, failures... but stay on topic. And watch for that hijacking.

Thread Tools
Old 12-02-2013, 08:28 AM   #1
On the road to being a farker
Join Date: 09-09-11
Location: Miami, FL
Default iq110 problems

I was wondering if someone could give me troubleshooting help with my iq110. I have 'tried' to use it 3 times and it never has gone passed 230*.

I fill up the ring on my WSM 18.5, haven't tried the 22.5 yet since I wanna master it with small cooks before big ones, and light a chimney up. Put the charcoals all over the unlit ones and build the WSM up. Close all the vents up, hook up my Maverick up and turn the 110 on to the desired temp. This is where the problems begin, the temp never makes it passed ~230* and takes about 2.5 hours to get there. On Thanksgiving I had to open up the vents in order to get it to ~245-250* (I had it set to 300*) and it slowly went up. Once I put the turkey on the temps dropped and the 110 started blinking red and eventually went in to solid red and didn't work again.

Am I doing something wrong? This is just about how the other 2 cooks went only difference was using ribs or a pork butt as compared to a turkey.
Youngin' is offline   Reply With Quote

Old 12-02-2013, 08:36 AM   #2
Babbling Farker

aawa's Avatar
Join Date: 07-03-12
Location: Yorktown

I would give the Pitmaster IQ team a call. You might have a defective unit.
Sublime Smoke Barbecue - Follow us on Facebook
Weber Performer
Sublime Smoke UDS
Lazy man Pitmaster IQ110 w/ rainbox

Superest Fasterest Blue Thermapen
aawa is offline   Reply With Quote

Old 12-02-2013, 09:15 AM   #3
brother steve
Got Wood.
brother steve's Avatar
Join Date: 05-24-11
Location: lewistown pa.

I had problems with mine. Sent it back and they said probe was bad. Used it two more times ,still acted up.I was so disgusted I just quit using it.It was supposed to make things easier.I do it the old fashion way. Would not recommend this unit!
brother steve is offline   Reply With Quote

Old 12-02-2013, 09:23 AM   #4
somebody shut me the fark up.

Fwismoker's Avatar
Join Date: 08-22-13
Location: Fort Wayne, Indiana

I have one and it's great. First try getting it up to temp the old fashion way and see if it keeps temp. Secondly do you have enough exhaust? If you don't then that could be your problem.
Cookers: Creator of Octoforks Rotisserie System U.S Patent Pending,
Mini WSM, Jumbo Joe mini WSM aka Jimmy w/ CB Roti & Meat hanging ring, 22.5" kettle w/ CB kit, Creator of the world famous 007 Super Grill Smoker Roti, Big Poppa UDS, gasser grill and Weber 22.5" kettle w/ CB Roti

Official 007 Thread: "007"
Fwismoker is online now   Reply With Quote

Old 12-02-2013, 09:42 AM   #5
somebody shut me the fark up.

gtr's Avatar
Join Date: 10-16-10
Location: Culver City, CA

When you say closed all the vents, does that include the top one for exhaust? The exhaust should be open. I have an iQue I used a few times and it was pretty cool, but it stopped working after around 10 cooks. I put it away and haven't really missed it.
50" Klose BYC, Spitjack XB85, 22.5 WSM, Backwoods Chubby, UDS, WRK, 26" & 22.5" Weber Kettles, Jumbo Joe, WGA, WSJ/MUDS, Jumbo Old Smokey, a piece of expanded metal I throw over the fire pit sometimes, Stealthy Black & Vol Orange Thermapens
Displaced East Tennesseean
Proud recipient of a Tick
Former outlaw MOINK baller, now IMBAS Certified, but still lookin' over my shoulder.
"Relax, it's only BBQ." - Bigmista, 2013
Avatar by my son!
gtr is offline   Reply With Quote

Old 12-02-2013, 01:46 PM   #6
On the road to being a farker
Join Date: 09-09-11
Location: Miami, FL

The top one was open also and it just doesn't get up to temp. I'm going to acll today and find out.
Youngin' is offline   Reply With Quote

Old 12-02-2013, 02:29 PM   #7
is one Smokin' Farker
Join Date: 07-08-12
Location: Murrieta ca

Order a new prob that should fix it.
Smoke This BBQ Team,Jambo Jr,2 BP UDS'S,2 Pellet Smokers
Wneill20 is offline   Reply With Quote

Old 12-03-2013, 05:55 AM   #8
Babbling Farker
Join Date: 06-29-11
Location: Greeneville TN

This seems more like a fuel and air management problem. Build another fire just like the problem one and use the lower vent to control the intake and see what happens. Could be just crappy fuel.
captndan is online now   Reply With Quote

Old 12-03-2013, 04:01 PM   #9
On the road to being a farker
Riz58's Avatar
Join Date: 06-26-12
Location: Four Corners Region, New Mexico

Using the ring of fire or Minion method, I have found I need to do two things to get to higher temperature: Open the vent on the unit one to two more clicks (at two or three), and open the top vent a bit more.

I use the vents on the pit to run the temperature to about 30 to 40 degrees of target and then clamp down the bottom vent and start the iq110. The top vent is partially closed. As it reaches temp, I leave the top vent open a crack (I use it on an Akorn Kamado) and it will settle in around 235 to 250 without problems.

If I need to run it up to 300 plus, I will open the vent on the ip110 to at least 3, if not four, open up the top vent some, let it run to temperature, and then bring the iq back to opening 2 and either leave the top vent where it is or close it slightly. It takes a lot more air to keep the hotter fire going. Once there and the iq vent is set to provide enough air, I have never had a problem maintaining temperature.
Regards, Riz58 Char Broil Akorn, Primo, custom-built, and Masterbuilt Electric Smoker
Riz58 is offline   Reply With Quote

Old 12-03-2013, 05:34 PM   #10
is one Smokin' Farker
BBQDaddio's Avatar
Join Date: 08-23-13
Location: San Gabriel, CA

Do not have a IQ110 but from my readings here on the forum. Try getting the pit almost to desired temp before closing off all the vents and letting the iq110 take over. The initial burn and coming to temp takes up alot of air. Maybe the reason why it takes so long to come up to your desired temp.

Give it a try.

Leave all vents wide open until the pit comes up to 265-275 than start closing the intake vents down while still leaving the exhaust fan wide open.

Set the iq110 to 300 degrees and it should take over and get the pit there and stabilize.
Q-ING on my: PBC, Weber OTG & Cookshack - Shirley 24 x 55 Cabinet Trailer Model on order.
BBQDaddio is offline   Reply With Quote

Old 12-03-2013, 08:06 PM   #11
is One Chatty Farker
Join Date: 09-11-11
Location: Baltimore, Maryland

I wait until the pit is up to temp and connect it.
"It's all about the Hill Country brisket."
Vision is offline   Reply With Quote

Old 12-03-2013, 09:26 PM   #12
Full Fledged Farker
EverettBBQ's Avatar
Join Date: 08-06-13
Location: Overland Park, KS
Default Rebel 17

I use it on a Rebel 17.
Works very well.
I use a independent thermometer to check IQ (has been nuts on).
Think about air flow.
What's your setting from 1 to 4?
Are you using the by-passing the open lid?
Are you using it to start your charcoal or keeping the temp correct?
Good luck
Do not give up
EverettBBQ is offline   Reply With Quote


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Forum Custom Search: Enter your Search text below. GOOGLE will search ONLY the BBQ Brethren Forum.

All times are GMT -5. The time now is 08:15 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.
no new posts