The BBQ BRETHREN FORUMS.


Our HomePage Recipes Smoke Signals Magazine Welocme Merchandise Associations Purchase Subscription Brethren Banners
Go Back   The BBQ BRETHREN FORUMS. > Discussion Area > Q-talk
Reload this Page My 1st UDS (Stainless)!!!
Register Downloads Arcade FAQ Calendar Mark Forums Read Chat Room [3]

Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, Equipment and just outdoor cookin' in general, hints, tips, tricks & techniques, success, failures... but stay on topic. And watch for that hijacking.


Reply
Page 4 of 4 123 4
 
Thread Tools
Old 08-30-2012, 05:24 AM   #46
Pastor B.
Found some matches.
 
Join Date: 05-29-10
Location: Between GA
Downloads: 0
Uploads: 0
Default
Ordered the bowl off of Amazon. Had a gift card and my portion ended up being $1. Can't wait for my bowl lid to arrive.
Pastor B. is offline   Reply With Quote

Old 08-30-2012, 10:40 PM   #47
javahog2002
Take a breath!
 
javahog2002's Avatar
 
Join Date: 10-02-09
Location: Longmont, CO
Downloads: 0
Uploads: 0
Default
Very nice. Where did u get the SS drum ? Cost ?
__________________
Smokemaster Offset*SSP:'95 Blue '00 Maroon*'69 22 Cado*'90 Red MT*WSM Mini'77 Red 18*'73 WSJ*ET-732
javahog2002 is offline   Reply With Quote

Thanks from:--->
Old 08-30-2012, 11:43 PM   #48
khs282
On the road to being a farker
 
khs282's Avatar
 
Join Date: 08-15-11
Location: Plymouth, MN
Downloads: 0
Uploads: 0
Default
Nice looking cooker. I like the stainless look. Great looking wings. Your nephew will be bbqing for life.
khs282 is offline   Reply With Quote

Thanks from:--->
Old 08-31-2012, 01:36 AM   #49
Q-Dat
Babbling Farker

 
Q-Dat's Avatar
 
Join Date: 12-03-08
Location: Pearl River LA
Downloads: 0
Uploads: 0
Default
Quote:
Originally Posted by Pastor B. View Post
Ordered the bowl off of Amazon. Had a gift card and my portion ended up being $1. Can't wait for my bowl lid to arrive.
OK I have to let you know that you will still need to do some work to make it fit, but in your case it will be easier than mine because I didn't have a lid already for the drum.

If you got the same bowl that I did, them the outside diameter is right at 22" this will not be big enough to cover the top, but all you will have to do is cut out the inside of your existing lid and mount the bowl to it.

Can't wait to see the finished product!
Q-Dat is offline   Reply With Quote

Thanks from:--->
Old 08-31-2012, 11:44 AM   #50
elyhill
Found some matches.
 
elyhill's Avatar
 
Join Date: 03-27-08
Location: syracuse,ny
Downloads: 0
Uploads: 0
Default
Check out amazon for a thermometer also, deep fry/candy got one for $6.50
elyhill is offline   Reply With Quote

Thanks from:--->
Old 08-31-2012, 01:09 PM   #51
Pastor B.
Found some matches.
 
Join Date: 05-29-10
Location: Between GA
Downloads: 0
Uploads: 0
Default
Thermometers arrived today. Waiting for mt stainless bowl to arrive to make a lid but I have a few lead on weber lids as well. I guess i will kepp all of the extras for my next build.

I am planning on putting on some ribs tonight and cook them overnight.

Javahog2002, the drum was free with a little horse trading for a stainless tighthead drum that I use to build BBQ grills.
Pastor B. is offline   Reply With Quote

Old 08-31-2012, 02:39 PM   #52
El Ropo
Babbling Farker

 
El Ropo's Avatar
 
Join Date: 10-06-10
Location: Austin, TX
Downloads: 1
Uploads: 0
Default
Quote:
Originally Posted by Pastor B. View Post
Thank El Ropo. I will look into lowering the exhaust next week. Do you have any suggestions for thermometers or will any ebay grill thermometer work just as well?
Look for a long stem candy/deep fry thermo that's 8-12" long, so you are getting a true reading of what the temp is close to center of top cooking grate. Install it so the tip is just under the grate. You can use the clip that comes with the thermo to slide it in and out, or you could get a fancy drilled out bolt installed, so the thermo slides in and out of that. The point is you need to be able to pull the thermo out when pulling or replacing the fire basket and bottom grate.

A short thermo won't give you accurate readings of what's goin on in the middle of drum.
__________________
Modded Brinkmann Gourmet. Basic UDS. Rescued 22.5" OTS. Weber SJS. Stubbs. B&B Oak Lump.

Cannondale 2009 F8 (for burning off all the great BBQ)
El Ropo is offline   Reply With Quote

Thanks from:--->
Old 08-31-2012, 02:54 PM   #53
FashionBiff
On the road to being a farker
 
FashionBiff's Avatar
 
Join Date: 04-15-12
Location: Chula Vista, Ca.
Downloads: 0
Uploads: 0
Default
Not sure what I like more, the drum or the tractor.... both shinny and pretty and both look better dirty
__________________
I want a Weber 1880.
FashionBiff is offline   Reply With Quote

Thanks from:--->
Reply
Page 4 of 4 123 4

Tags
1st, stainless

« Previous Thread | Next Thread »
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Loading



All times are GMT -5. The time now is 01:10 AM.

Contact Us - BBQ-Brethren Homepage - Archive - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2013, vBulletin Solutions, Inc.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.