LT72884
Babbling Farker
Ok, so here is my set up. As you can see from the pic, i have foil drip pan and lump on one side of the kettle. It is only 3/4th a weber chimney full of unlit. I removed the chunk before i put the lit stuff on. Lit 1/4th a chimney full of a new bag of lump. waited 5 to 8 minutes till it was clean and red edges., poured that right over the unlit charcoal. Then placed wood chunks right on the center of the lit coal. The book said to wait 5 minutes for the white smoke to clear. so i waited 3 minutes because i noticed the lump was fetching hot and the unlit was all lit... No smoke. cloased the lid. BAM, tons and tons and tons of white smoke. So bad that in 2 or 3 minutes i had to pull what was left out of the wood chunks out. They were completly carbonized.... I have tried the method where you mix wood chunks in the unlit stuff, same luck.. forgot to mention. the clean fire was at 350 lid temp and roughly 300 grate.
Here is the setup:I removed the first wood chunks and placed after the lit charcoal was poured on:
here is the pic of clean exhaust before wood chunk.
the carbonized wood after 2 or so minutes.
What happened? haha.
thanx guys. I know its anoying when i ask my questions but believe you me, this is anoying the he!! outa me. ahahaha
Here is the setup:I removed the first wood chunks and placed after the lit charcoal was poured on:
here is the pic of clean exhaust before wood chunk.
the carbonized wood after 2 or so minutes.
What happened? haha.
thanx guys. I know its anoying when i ask my questions but believe you me, this is anoying the he!! outa me. ahahaha