32F reading on Memphis grill

Huskres · 12-15-2018, 03:02 PM

Getting a 32f reading on the grill. Will run for awhile then shutdown with ER2 code. Any help?

jasonjax · 12-15-2018, 03:07 PM

Received*Error* Message*"ER‐2"

•*The*appliance*has*failed*to* ignite*within*the*allotted*30* minutes.
•*Check*the*hopper*for*sufficient*fuel. •*Check*the*burn*pot*for*ash*build‐up*or*other*obs tructions. •*Check*igniter*to*see*if*it*is*heating*up(igniter *may*need*replacing). •*In*extreme*cold,*grill*may*require*additional*pr iming*to*achieve* ignition. •*Make*sure*hood*is*closed.** •*Grill*will*not*stay*lit. •*Check*the*hopper*for*sufficient*fuel. •*Check*the*burn*pot*for*ash*build‐up*or*other*obs tructions. •*Make*sure*hood*is*closed.

ITC*Constantly* Reads*32
•*Damaged*ITC •*Contact* your dealer or Heartland Products

I found that on the Memphis site under one of the manuals.

Joshw · 12-15-2018, 03:23 PM

I would guess ignition problem. Make sure your fire pot is clean. Unplug for a few minutes, then plug it back in. Keep an eye on the fire pot. If it doesn't light in a few minutes, light it with a torch. See if to runs good from there.

Huskres · 12-15-2018, 03:31 PM

I’ve lit it with a torch and it still died out

jasonjax · 12-15-2018, 04:20 PM

Quote:

Originally Posted by Huskres

I’ve lit it with a torch and it still died out

I think your ITC (Intelligent Temperature Control) has gone bad. There is definitely drawbacks to technology, but to me the benefits far outweigh the negatives. Always have a backup plan.

BKING! · 12-15-2018, 04:23 PM

Sorry about your grill. Hope it gets sorted out soon

Huskres · 12-15-2018, 05:04 PM

Quote:

Originally Posted by jasonjax

I think your ITC (Intelligent Temperature Control) has gone bad. There is definitely drawbacks to technology, but to me the benefits far outweigh the negatives. Always have a backup plan.

Hmm. If the whole controller went bad I have an old rectec one. Same design but not set up for it. Or the new rectec WiFi one is 100 bucks.

jasonjax · 12-15-2018, 05:21 PM

Quote:

Originally Posted by Huskres

Hmm. If the whole controller went bad I have an old rectec one. Same design but not set up for it. Or the new rectec WiFi one is 100 bucks.

I'd call Memphis and see what they have to say before I tried to retrofit anything.

Smoking Cajun · 12-16-2018, 08:44 AM

It might just be a bad temperature probe. When they go bad, you get all kinds of crazy readings.

12-15-2018, 03:02 PM	#1
Huskres Full Fledged Farker Join Date: 04-20-14 Location: Oklahoma	32F reading on Memphis grill Getting a 32f reading on the grill. Will run for awhile then shutdown with ER2 code. Any help?

12-15-2018, 04:23 PM	#6
BKING! is One Chatty Farker Join Date: 01-26-18 Location: Talbott, TN Name/Nickname : Brent	Sorry about your grill. Hope it gets sorted out soon __________________ Current:Mak ⭐️ general, Weber kettle 26, camp chef 900 griddle

12-16-2018, 08:44 AM	#9
Smoking Cajun Full Fledged Farker Join Date: 07-04-18 Location: Richmond, Tx Name/Nickname : Brent	It might just be a bad temperature probe. When they go bad, you get all kinds of crazy readings. __________________ Delta Heat 32" gas grill, Yoder YS640

12-15-2018, 03:07 PM	#2
jasonjax Babbling Farker Join Date: 12-20-07 Location: Ponte Vedra, Florida Name/Nickname : Jason	ReceivedError Message"ER‐2" •Theappliancehasfailedto* ignitewithintheallotted30* minutes. •Checkthehopperforsufficientfuel. •Checktheburnpotforashbuild‐uporotherobs tructions. •Checkignitertoseeifitisheatingup(igniter mayneedreplacing). •Inextremecold,grillmayrequireadditionalpr imingtoachieve* ignition. •Makesurehoodisclosed.* •Grillwillnotstaylit. •Checkthehopperforsufficientfuel. •Checktheburnpotforashbuild‐uporotherobs tructions. •Makesurehoodisclosed. ITCConstantly Reads32 •*DamagedITC** •Contact your dealer or Heartland Products I found that on the Memphis site under one of the manuals.

12-15-2018, 03:23 PM	#3
Joshw Babbling Farker Join Date: 09-25-17 Location: Oklahoma	I would guess ignition problem. Make sure your fire pot is clean. Unplug for a few minutes, then plug it back in. Keep an eye on the fire pot. If it doesn't light in a few minutes, light it with a torch. See if to runs good from there.

12-15-2018, 03:31 PM	#4
Huskres Full Fledged Farker Join Date: 04-20-14 Location: Oklahoma	I’ve lit it with a torch and it still died out