|
Competition BBQ *On Topic Only* Discussion regarding all aspects of Competition BBQ. Experiences competing or visiting, questions, getting started, Equipment, announcements of events, Results, Reviews, Planning, etc. Questions here will be responded to with competition BBQ in mind. |
|
Thread Tools |
07-20-2013, 11:46 AM | #1 |
is One Chatty Farker
Join Date: 04-08-10
Location: Elk Creek, KY
|
Backwoods help needed
Have a new Competitor and Guru, new to these smokers and Gurus. No matter what temp I try to cook at, the smoker runs high at 20-30 degrees over set temp. This happens with fan at 1/3 setting, other vent closed and exhaust vet barely open. Water level is fine, doors are as tight as possible, fuel is in a "S" pattern. Any suggestions?
|
|
07-20-2013, 11:55 AM | #2 |
Babbling Farker
Join Date: 01-16-07
Location: Southern MN
|
Next time you start your cooker, as soon as your cooker gets to your desired temp, open the firebox and slide out your coal tray. Check to see how many coals are lit.
__________________
Dan MJH From Backyard Bomber BBQ -- Junior YS 640 Comp 22.5 Weber Kettle Blue Thermopen Comp Team Wine & Swine |
|
07-20-2013, 12:18 PM | #3 |
is one Smokin' Farker
Join Date: 09-30-11
Location: Beebe, ar
|
What do u mean "fan at 1/3 setting". I have the exact set up and it will do 225* for 12+ hrs.
__________________
Myron Mixon Smoker 60 h2o |
|
07-20-2013, 12:26 PM | #4 |
is One Chatty Farker
Join Date: 09-09-07
Location: Phoenix, AZ
|
Don't Guru fans have a damper that can be opened and closed to a desired setting to allow for more or less air flow? That may be what he means by 1/3 setting.
__________________
Rhythm 'n QUE Our Website On Facebook A Few Great Moments in RnQ History 1st Place Chicken at The Jack 2012 GC at the Inaguaral Sam's Club Invitational The Double Grand Championship |
|
07-20-2013, 12:33 PM | #5 |
is One Chatty Farker
Join Date: 02-11-10
Location: Northern VA
|
For me, I fill the basket up as much as possible! And I mean full! The Guru will determine the burn rate for the most part. I am under the impression that using the snake pattern is for when you do not have a Guru; that controls the burn rate.
The WiFi Guru will actually "learn" your smoker and the type fuel you are using and adjust itself so as not to overshoot or let the temp fall to low. Is temp you are referring to what is shown on the Guru? Also, my fan damper is wide open, opposite side vent closed, and top exhaust open about the width of my index finger. When I first start it, I have the exhaust wide open till it gets about 200*. Then, I close it to finger width. wallace
__________________
wallace(Don) - Life Is Good But BBQ Is Better - BWS - Fat Boy - WSM 22.5 - A bunch on other outdoor cooking stuff. - KCBS CBJ# 58657 - MABA Member "Take luck!" |
|
07-20-2013, 12:33 PM | #6 |
is One Chatty Farker
Join Date: 04-08-10
Location: Elk Creek, KY
|
|
|
07-20-2013, 12:49 PM | #7 |
On the road to being a farker
Join Date: 04-19-12
Location: Broken Arrow OK
|
First, I LOVE my BBQ Guru on my Big Green Egg. Best money I ever spent on an accessory for a cooker.
I bought a used Backwoods Gater and an adapter plate for the Guru. I found it easier to regulate my heat on the Backwoods without the Guru rather than with it. Remember my cooker was used, and not nearly so air tight as a new one, and that may be a factor in my results. I wrote a post to the Backwoods-Smoker forum titled "My How-To Guide" on my experience with Backwoods setup. Link here: http://www.backwoods-smoker.com/foru...php?f=4&t=8509 I am sure others disagree, just my opinion......
__________________
Know Bull |
|
07-20-2013, 01:09 PM | #8 |
Babbling Farker
Join Date: 01-16-07
Location: Southern MN
|
IMO, on a competitor, durring warm-up, the fan has to stay ON so long that it ignites far too many coals resulting in over-shot temps. Sometimes even though you are using a fuse or s-burn. Coals will still ignite on both sides of the metal.
__________________
Dan MJH From Backyard Bomber BBQ -- Junior YS 640 Comp 22.5 Weber Kettle Blue Thermopen Comp Team Wine & Swine |
|
Thanks from:---> |
07-20-2013, 01:33 PM | #10 |
is One Chatty Farker
Join Date: 04-08-10
Location: Elk Creek, KY
|
I let it come up to temp before turning on the fan. Only coals burning are within the metal. I'm at a loss.
|
|
07-20-2013, 01:37 PM | #11 |
is One Chatty Farker
Join Date: 02-11-10
Location: Northern VA
|
Another thing I learned, is to bring the unit up to temp slowly.. Get it up to 150, then 180, then 200, then 225-235 which is where I try to cook at.
I let the temp stabilize at each temp before climbing up. I get about 8-9 hours cook time with. Full bracket of lump. wallace
__________________
wallace(Don) - Life Is Good But BBQ Is Better - BWS - Fat Boy - WSM 22.5 - A bunch on other outdoor cooking stuff. - KCBS CBJ# 58657 - MABA Member "Take luck!" |
|
07-20-2013, 01:38 PM | #12 | |
is One Chatty Farker
Join Date: 02-11-10
Location: Northern VA
|
Quote:
Thanks! wallace
__________________
wallace(Don) - Life Is Good But BBQ Is Better - BWS - Fat Boy - WSM 22.5 - A bunch on other outdoor cooking stuff. - KCBS CBJ# 58657 - MABA Member "Take luck!" |
|
|
07-20-2013, 01:41 PM | #13 |
Babbling Farker
Join Date: 05-19-11
Location: EAD
|
start closing off the vents earlier as you get to temp? the underlying problem is your ending up with a fire bigger than you need to sustain your target temps.
are you getting air leaking through the non guru vent that you dont know about? Its pretty common to see bws with the non guru vent taped off to eliminate air leaks cant rush insulated reverse flow verticals. far to efficient to just bleed off excessive heat |
|
07-20-2013, 02:03 PM | #14 |
somebody shut me the fark up.
Join Date: 10-27-06
Location: Bothell WA
|
All good advice in this thread.
Waiting for the BWS to come up to temp just kills me! One method that I gleaned from the BWS forum for starting was removing the heat deflector and filling the waterpan as the pit starts reaching your desired temp. I speed things up by preheating (and burning/cleaning off the cook grates) the cook chamber with my weed burner, replace the deflector, check the coal tray to see how much has fired off and set the Guru with the pit probe on the door thermo.
__________________
Brian - Left Hand Smoke BBQ PNWBA 2010 Team of the Year BGE's/WSM's/Pellet Pro WSM/BWS Gater/BDS Clones/Cookshack 008/Weber Performer w EZ-Que/Cajun Bandit/Rib-O-Lator Test Pilot/La Caja China/BBQ Guru/Weber 1000 RK Drum Coffee Roaster Follow Left Hand Smoke on Facebook!http://www.facebook.com/pages/Left-H...462391?sk=wall KCBS CBJ/PNWBA CBJ www.pnwba.com |
|
07-20-2013, 02:45 PM | #15 |
Full Fledged Farker
Join Date: 10-20-09
Location: Midland VA
|
I will add my technique I use in my Extended Party and Fatboy. I fill the basket pretty full, about 10 lb. of charcoal and light an absolute minimum number of briquettes, about 10 in a chimney (yes I use briquettes and this isn't intended to be a discussion on briquettes vs. lump). Place them in a corner away from the fan and set the Guru for 150. I let the temp come up slowly to 150 and stabilize for 5-10 minutes, then I set to 180. Repeat for 210 and then set final temp. That seems to work pretty good for me. I run a 25CFM fan wide open and top vent open about two fingers. The down side is this can take awhile, but I have time at a comp so I take the time needed. I get a good solid overnight cook out of that technique.
__________________
http://deguellobbq.wordpress.com |
|
Thanks from:---> |
|
|