Sammy_Shuford is Blowin Smoke! Joined May 18, 2009 Messages 1,668 Reaction score 893 Points 0 Location Summervi... Jul 1, 2013 #1 as the Rib-O-Lator works in to own ring, on top of my UDS, could I not run the Rib-O-Lator in the ring, and the top grate all full of ribs? Anyone done this?
as the Rib-O-Lator works in to own ring, on top of my UDS, could I not run the Rib-O-Lator in the ring, and the top grate all full of ribs? Anyone done this?
HeSmellsLikeSmoke somebody shut me the fark up. Joined Apr 2, 2007 Messages 8,044 Reaction score 1... Points 0 Age 83 Location Warren... Jul 1, 2013 #2 I thought the rib-o-lator goes slightly below the ring? If so there woudn't be enough clearance, would there?
I thought the rib-o-lator goes slightly below the ring? If so there woudn't be enough clearance, would there?
S Smokin' D is Blowin Smoke! Joined Dec 11, 2007 Messages 1,168 Reaction score 296 Points 0 Location N... Jul 1, 2013 #3 My R-o-L is also in its own ring that sits atop a drum. Not much room above, but I always have a grate under to catch any falling mishaps. Suppose a few items could go there as well as on the Merry-go-Round.
My R-o-L is also in its own ring that sits atop a drum. Not much room above, but I always have a grate under to catch any falling mishaps. Suppose a few items could go there as well as on the Merry-go-Round.
S SmokerKing is One Chatty Farker Joined Sep 7, 2010 Messages 2,232 Reaction score 1... Points 0 Location Sunny AZ Jul 1, 2013 #4 I drilled holes in the side, shortened and welded in threaded nipples, bolted the motor bracket and rod bracket to the sides. When done, just use a 3/4" threaded cap, all sealed up for smoking.
I drilled holes in the side, shortened and welded in threaded nipples, bolted the motor bracket and rod bracket to the sides. When done, just use a 3/4" threaded cap, all sealed up for smoking.