BriGreentea
Knows what a fatty is.
I got an annoying issue with my 18" WSM getting water inside the ash pan due to I had a cover it came with and within a short amount of time the cover which was already way too tight to begin with, got to the point it shrank from the heat so didn't fit anymore and tossed it.
I don't have an overhead patio and due to the design of the lid it fits on top of the lip instead of over the lip. WHY Weber did this I have no idea! I used to have a UDS with a bunghole and could smoke for hours and hours in a thunderstorm with little worries!
Is there a modified lid that can possibly fit inside the lip and go over it so rain doesn't get down in the bottom? My choices if not are to get another cover when not in use or drill a small hole on the bottom to drain any water and have a pan under.
I like to reuse the charcoal that's left if possible but when it's all mush it's unusable and messy.
I don't have an overhead patio and due to the design of the lid it fits on top of the lip instead of over the lip. WHY Weber did this I have no idea! I used to have a UDS with a bunghole and could smoke for hours and hours in a thunderstorm with little worries!
Is there a modified lid that can possibly fit inside the lip and go over it so rain doesn't get down in the bottom? My choices if not are to get another cover when not in use or drill a small hole on the bottom to drain any water and have a pan under.
I like to reuse the charcoal that's left if possible but when it's all mush it's unusable and messy.