Twelvegaugepump
is one Smokin' Farker
I got ahold of an old Philco fridge for free.
I would love to make a smoker for sausage due to the ability to hang meat with this setup. The inside of the door is plastic as is a small section around the inside. If I remove those and the insulation, could I install a gas burner and a cast iron pan to hold chips? I understand I lose some insulating ability, but with the cost of steel, I am not sure I can afford to re-line it. I just spent 300 dollars on angle iron for a trailer build. Anyone done anything similar?
I would love to make a smoker for sausage due to the ability to hang meat with this setup. The inside of the door is plastic as is a small section around the inside. If I remove those and the insulation, could I install a gas burner and a cast iron pan to hold chips? I understand I lose some insulating ability, but with the cost of steel, I am not sure I can afford to re-line it. I just spent 300 dollars on angle iron for a trailer build. Anyone done anything similar?