|
Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, equipment and outdoor cookin' . ** Other cooking techniques are welcomed for when your cookin' in the kitchen. Post your hints, tips, tricks & techniques, success, failures, but stay on topic and watch for that hijacking. |
|
Thread Tools |
06-29-2011, 04:19 PM | #8161 |
Found some matches.
Join Date: 06-22-11
Location: Williamsport, PA
|
Hello Brothers,
Just about to start my 1st ubs and I've learned alot here so far. My question is it better to have one large exhaust on the lid or six or eight smaller holes to allow for the correct draw? Thanks..... |
|
06-29-2011, 07:13 PM | #8162 |
Got Wood.
Join Date: 04-07-11
Location: Northern Calif.
|
Uds
|
|
06-29-2011, 10:21 PM | #8163 | |
Knows what a fatty is.
Join Date: 05-18-09
Location: McPherson KS
|
Quote:
And "cheap charcoal"? I use the cheap WallyWorld charcoal if I'm going to use briquettes. No nasty smell/aftertaste like Kingsford leaves. I prefer lump instead of the compressed stuff. If anything, I'll second the idea that you're using way too much flavor wood. |
|
|
06-30-2011, 09:11 AM | #8164 | |
Knows what a fatty is.
Join Date: 11-26-10
Location: Somewhere, CT
|
Quote:
I happen to have currently a 3" hole coming out the side, and then I use 3" duct piping to make a smoke stack. I used a 24" pipe (after an elbow). It works too well; lots of draft. I will cut that pipe into two 6" sections. Sometimes on windy or cold days, I need more draft, or if I'm smoking over night as the temps and moisture change dramatically. My friend has four 1" pipes on the sides, each one with an elbow and just 4" pipe going up. It works well for him. Four 1" open holes is same circular area as one 2" hole. |
|
|
06-30-2011, 11:03 AM | #8165 | |
Knows what a fatty is.
Join Date: 03-17-08
Location: Roseburg, OR
|
Quote:
I keep reading that people put several "fist size" chunks of smoke wood in their basket - and though it may not look like it, I only had about one "fist size" amount of pieces in my basket, maybe a little more. When I was sifting through the remaining charcoal there were only 3 pinky to thumb size pieces of smoke wood that burned during the 3 hour run - all the others looked untouched. Do you think the smaller pieces would produce too much smoke? I've "over smoked" in my GOSM before and the smell was nothing like the ashtray smell in the drum. On my second run in the drum I used 1 fist size chunk of apple and 2 thumb size pieces of hickory and it worked out good - so who knows, it may have been too much smoke wood. I need to pick up a new bag of hickory chunks so I actually have "chunks" - I'm down to mostly thumb size pieces and smaller in my bag. I'd really like to try using lump, but I figured the briquets would be easier to learn on, plus I stocked up during the last big sale at Home Depot.
__________________
Traeger Century, UDS, GOSM Big Block, Chargriller without side firebox, Gas Grill |
|
|
06-30-2011, 12:54 PM | #8166 |
Found some matches.
Join Date: 05-24-11
Location: Long Island
|
Iv'e been having the white smoke problem too but i thought it had something to do with moist coals becasue it had been raining so much lately. Last smoke i did was a chicken and I didn't put a drip pan in there so maybee the fat mixing with the coals was it......not sure but more and more im thinking i need to refine my Kingsford minion technic, its coming out way too smokey and not the good kind of smoke, its the creosote tasting smoke.
|
|
06-30-2011, 03:47 PM | #8167 |
Knows what a fatty is.
Join Date: 04-07-11
Location: Ellwood City, PA
|
so, finally finished my UDS
Here's my (blurry) UDS. A former apple juice barrel with a yellow liner. Removed the liner with a combination of wire wheel and burn.
One 3/4" vent at the rear with a screw-on cap, welded in, home-built sliding vent at the front with an 1-3/4" vent hole made from aluminum sheet I had lying around. Bent and shaped with a hammer, cutoff wheel, and a bench vise. Charcoal basket is #9 expanded steel wrapped around a charcoal grate from a $25 Big Lots 22.5" grill, wired on with coathanger wire and welded along the seam (oxyfuel torch). 16" pizza pan for an ash pan. It seems fairly large to me, so it should hold plenty of charcoal for long burns. The lid is also from the Big Lots grill, fits like a glove. No mods needed. I may re-use the wheels and legs from the Big Lots grill to put wheels on this thing, but I don't need 'em for now, I can use my dolly if I have to move it around. Sanded the whole thing, sprayed the outside with high-temp paint. Thermometer (not pictured) is a turkey fryer thermo from Walmart. Dropped it in boiling water to test, came up pretty darn close. I only have a single grill in it for now, also from the Big Lots grill. I may add a second grill later. Thanks for the thread, it was very instructive! I'm on-call to work on the 4th, so I'm stuck at home. I'll make the most of it with a maiden voyage of the UDS, a fatty, and maybe a pork shoulder. |
|
06-30-2011, 04:12 PM | #8168 |
On the road to being a farker
Join Date: 06-20-11
Location: Frisco, Texas
|
So....this lid fit perfectly with no mods necessary? I may have to check out Big Lots. Does your barrel have the lip on it?
__________________
UDS |
|
06-30-2011, 04:46 PM | #8169 | |
Knows what a fatty is.
Join Date: 04-07-11
Location: Ellwood City, PA
|
Quote:
I did shorten and re-weld the locking ring, as I had considered using the bottom half of the Big Lots grill as a bottom for the UDS - it has a vent built in. I decided the UDS would end up too tall as a result, so I didn't use it. I'll find some other use for it later, I'm a terrible packrat. |
|
|
06-30-2011, 10:45 PM | #8170 |
Is lookin for wood to cook with.
Join Date: 02-07-11
Location: Spokane, WA
|
2nd UDS
First let me say I'm the farthest thing from a Raiders fan. In fact, I'm a diehard Bronco fan; however, I do have a very close friend who is a Raider fan and thought this would be a great birthday present. This is my 2nd UDS build. My personal UDS is emphasizes on the "U" in UDS.
The handle is a Ham bone with multiple clear coats. Tell me what ya think! |
|
06-30-2011, 10:47 PM | #8171 |
Is lookin for wood to cook with.
Join Date: 02-07-11
Location: Spokane, WA
|
Oh, i forgot... Thanks to all the help and great info on this forum!!!
|
|
07-01-2011, 01:53 PM | #8172 | |
Knows what a fatty is.
Join Date: 11-26-10
Location: Somewhere, CT
|
Quote:
Perhaps you guys needed to clean out the sides of the barrel more? Or maybe indeed you've got some unwanted fuel burning. BTW, if you air flow is not good, you'll add to the creosote development. And it also increases with certain weather conditions. Mostly, if you don't have enough draft pulling air through, it could be a problem. And certainly once in a while you have to clean out your UDS. I have to "service mine" now actually. :) Though nothing ever comes out tasting bad from it. I have a smoke stack that pulls the air and just keeps the meaty goodness coming. :) Oh.. and when I smoke chicken, I actually bring it a little lower to the fire, and smoke it at like 350 degrees. Makes the skin nice and crispy and the chicken still comes out amazing. |
|
|
07-01-2011, 07:12 PM | #8173 |
Is lookin for wood to cook with.
Join Date: 01-01-11
Location: St. Cloud, FL
|
|
|
07-01-2011, 09:57 PM | #8174 |
Full Fledged Farker
Join Date: 06-02-10
Location: Loveland, CO.
|
Chico, love the handle man Top notch
__________________
Chargriller Acorn... UDS... Webber OTG... Camp Chef FTG 600 |
|
07-02-2011, 04:36 PM | #8175 |
Wandering around with a bag of matchlight, looking for a match.
Join Date: 07-01-11
Location: McDonough, GA
|
Heat Diffuser or Not?
I'm building my first UDS next week and I see a few designs with a Heat Diffuser and Water pan between the firebox and the cooking great, but most designs do not. Is this just personal necessary or personal preference?
|
|
Tags |
divided circle template, uds, ugly drum, ugly drum grill, ugly drum smoker |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ugly Drum Smoker | ironslob | Q-talk | 2 | 09-19-2010 10:16 AM |
Ugly Drum Smoker - Need Help | Bartkowiakj | Q-talk | 10 | 06-18-2010 09:38 PM |
One Ugly Drum Smoker | Steve_B | Q-talk | 15 | 09-21-2009 10:32 PM |
My (not-so) Ugly Drum Smoker. | hav | Q-talk | 47 | 11-05-2008 02:30 PM |
Ceramic Cooker Meets Ugly Drum Smoker - BUDCS - Concept Drum Discussion | Hook_Line_and_Sinker | Q-talk | 9 | 04-26-2008 02:24 PM |
|
|