|
Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, equipment and outdoor cookin' . ** Other cooking techniques are welcomed for when your cookin' in the kitchen. Post your hints, tips, tricks & techniques, success, failures, but stay on topic and watch for that hijacking. |
|
Thread Tools |
04-02-2013, 02:00 PM | #16 |
somebody shut me the fark up.
Join Date: 07-08-10
Location: Texas
|
Leaks above your fire level are less of a problem than leaky bottom vents. Be careful adjusting the bottom vents, they bend easier than I think they should. Convection will draw air through leaky bottom vents, and run your temperatures up.
Since I now use an iQue 110, I sealed my other two bottom vents up. CD |
|
Thanks from:---> |
04-02-2013, 02:47 PM | #17 |
Got Wood.
Join Date: 02-25-13
Location: Bay Area, California
|
At first I struggled to get my temps under control with the WSM, but the more grease that built up inside to create a seal has helped it maintain a consistent burn.
A few observations I have noticed: * On very hot days the WSM can be difficult to keep at around 225 - 250. Good use of the water pan helps here. * Always crack open the bottom vents equally - if you have one of the vents closed more than the other the temp seems more complex to control. * I usually control the top vent first when adjusting temp and then the bottom ones next - some folks leave the top vent open all the time but I have struggled to keep my temp under control there. On my last cook I made the mistake of throwing some big chunks of wood in there at first and this caused some flare ups which adjusted my temps, as you can see in my cook log at http://www.bbqpad.com/85/ - I think in the future I will break my wood up so there is less concentrated heat on each block.
__________________
See my cook logs at http://www.bbqpad.com/users/jonobacon/ - cooking on a WSM 22". |
|
Thanks from:---> |
04-02-2013, 02:57 PM | #18 |
On the road to being a farker
Join Date: 02-28-13
Location: Nashville, TN
|
This has been a helpful thread!
__________________
[B]Shane[/B] [B]UDS-WSM[/B] [B]KCBS, Certified Judge# 59992[/B] [B]Cook Team[/B] @ [URL="http://WolfCandyBBQ.com"]WolfCandyBBQ.com[/URL] [B]Web Designer[/B] @ [URL="http://barbecuewebsites.com"]BarbecueWebsites.com[/URL] |
|
Thanks from:---> |
04-02-2013, 03:10 PM | #19 |
Take a breath!
Join Date: 05-26-09
Location: Fulshear, Texas
|
Mine leaks a little smoke around the door and at various spots in the joints, but it is still relatively new (4 cooks). If I am using the IQUE and keeping the bottom vents closed, I can close the top vent and knock the temp down like a rock, so I'm not real concerned about a few small leaks. When I'm not using it, I keep a bungee cord around the door to hold it against the side of the cooker and it seems to be getting better in that regard. The big one uses a lot of fuel compared to the 18.5 I had before.
__________________
BBQ Apprentice - Old Country Brazos offset, 22.5 WSM, Various gassers, portable grills, etc. |
|
Thanks from:---> |
04-02-2013, 04:32 PM | #20 | ||
somebody shut me the fark up.
Join Date: 07-14-06
Location: Wyocena/Pardeeville, WI
Name/Nickname : Clark
|
Quote:
Quote:
Of course, there are times when I have 2 vents closed and the third open jus a little bit.
__________________
Clark My Boys: Joseph (EI); Andrew (EE); Daniel (EE) My Toys: 10 WSMs (B, C, E, DH, DA, EZ, DZ, EO, DU, DR); 5 - 22.5" Bar-B-Q-Kettles; 2 - 18.5" Bar-B-Q-Kettle; 4 WGAs (EZ, DE, N, B); 2 SJPs ( DR, DR); 2 Smokey Joes (A, K); Brinkman Cimmaron. "For when democracy becomes tyranny, those of us with rifles still get to vote" |
||
|
04-02-2013, 04:40 PM | #21 |
On the road to being a farker
Join Date: 07-06-07
Location: sc
|
I have had problems controlling temps with mine as well. I have had it about 18 months and have to be real careful to start with just a couple of lit coals and start shutting the vents at 150 or so. I know my door leaks as all do but also believe one of my bottom vents is slightly raised when shut and may be drawing in some air. Hope you find your problem, the weber folks are good with working with you if you can't.
|
|
Thanks from:---> |
04-02-2013, 09:32 PM | #23 |
is one Smokin' Farker
Join Date: 09-18-12
Location: Lugoff, SC
|
I've got about 15 cooks on mine now. It still leaks around the door a little but I'm not sure that's ever going to change. I have very little smoke coming from around the joints. I use the Digi-Q to control temps most of the time. The temp at the bottom rack is usually 15* cooler on my 22.5.
Maybe the Cajun Bandit door is better - I'm just not sure it's worth the cost. |
|
Thanks from:---> |
04-02-2013, 10:29 PM | #24 | |
is Blowin Smoke!
Join Date: 02-17-10
Location: San Antonio, TX
|
Quote:
|
|
|
Thanks from:---> |
04-03-2013, 08:29 AM | #25 |
is one Smokin' Farker
Join Date: 07-20-12
Location: Springfield, MO
|
If your door is bad enough to need changing, Weber will replace it at no cost. I still get a little smoke out the door when the fan kicks on, but I don't expect airtight. If you take your time you can shape the door to fit better. I think they all get flattened a bit in shipping, at least the last 4 that I have been a part of putting together.
Bottom grate is generally 4-10 degrees different than top rack and it will vary depending on whether you use a foiled pan, foiled with heat sink, or foiled with water in pan.
__________________
Smooth Smoke BBQ Team, KCBS CBJ, porch mounted Jambo. |
|
Thanks from:---> |
04-03-2013, 10:03 AM | #26 |
Babbling Farker
Join Date: 08-11-03
Location: St. Louis
|
I'll throw out a disagree with the suggestion of cracking all bottom vents and not just one. I use only one in order to better control mine and find I can fine tune temp just a couple degrees with just the one.
However, like CD I now use an IQue on mine which makes it super easy. In fact, I actually drilled in a UDS style pipe nipple so that I get a direct connect without the canister attachment and it works super easy. The doors I've put foil ducting tape over to completely seal them as I don't use a water pan or a clay pot. I can easily maintain anywhere from 190 to 350. The main thing would be, whatever you learn over these first 5 or 10 cooks will, in the long run, be a bit irrelevant. Your pit is going to change after a few cooks. So just chuck some pork butts and fatties on there and run it without having to worry too much about temp and get some wear on it. Then you'll be able to start really working on controlling it.
__________________
Neil -- "Easy Bake Master" NB Bandera [gone to heaven...conveniently located in Long Island, NY] Rebel 23, WSM A, WSM B, UDS, Easy Bake Oven Pork Pistols BBQ MOFO Illuminati MOINK...It's what's for linner. |
|
Thanks from:---> |
04-03-2013, 10:26 AM | #27 |
is One Chatty Farker
Join Date: 01-16-12
Location: Winfield, IL
|
I usually use a single bottom vent to control temperatures on my WSMs (with the other two remaining closed.)
I had trouble controlling temperature on the first couple cooks so I ran a bead of high temp silicone around the bottom edge of the middle section.
__________________
Weber Crazy |
|
Thanks from:---> |
04-03-2013, 12:46 PM | #28 |
is One Chatty Farker
Join Date: 09-09-07
Location: Phoenix, AZ
|
This is an excellent idea! Thank you!
__________________
Rhythm 'n QUE Our Website On Facebook A Few Great Moments in RnQ History 1st Place Chicken at The Jack 2012 GC at the Inaguaral Sam's Club Invitational The Double Grand Championship |
|
Thanks from:---> |
04-03-2013, 01:10 PM | #29 |
Full Fledged Farker
Join Date: 12-26-12
Location: Goode,VA
|
Excellent feedback folks.
I didn't have temp problems, but it was only a 5 hour cook. I was very concerned that with all of the leaks, the coals would try to pull air from them. Great suggestions and thanks for helping out. I really love this thing. Dave
__________________
Proud member of the [URL=http://www.bbq-brethren.com/forum/showthread.php?t=155673]Zero's Club[/URL] |
|
|
|