Fire help

A couple of things... 1) What kind of wood are you using? 2) Are you letting the smoke clean up before adding your meat? 3) When adding new charcoal, are you pre-lighting it?

Those are the three things that come to mind immediately.

To add to that, is the exhaust wide open? Are your wood splits fully dry and cured?

sliding_billy said:

A couple of things... 1) What kind of wood are you using? 2) Are you letting the smoke clean up before adding your meat? 3) When adding new charcoal, are you pre-lighting it?

Those are the three things that come to mind immediately.

Click to expand...

Diesel Dave said:

To add to that, is the exhaust wide open? Are your wood splits fully dry and cured?

Click to expand...

I had used one a long time ago when I first started.

YES, they do burn through charcoal because they many air leaks which makes the coals harder to control. If there is too much smoke I would start with the first 2 items which were pointed out above. 1) Start your charcoal in a chimney and add it AFTER they start to appear orange in color. 2) make sure your exhaust is fully open all the time.

From there if it is still to smokey in flavor try reducing the amount of wood that you add. A smaller smoker will not require as much wood to flavor the meat. Lastly all charcoal is not created equal, many have additives than can cause heavy flavors to the meat. In most circumstances it is not noticeable, but it can be more pronounced in smaller smokers, thus putting the charcoal in after it has started to turn orange.

Keep us posted on your progress.

To build on IamMadMan ;Chicken sucks up smoke like a sponge Cut back on the wood If your just doing a bird 1 man fist chunk is more than enough to get the job done. If your not using lump you should really give it a try, It burns much cleaner less chance of over smokin.

A few things come to mind.
1) Use the right type of wood for your meat...don't use too strong for poultry.

2) Don't use too much wood

3) Try to keep a small hot fire vs a bigger smoldering fire.

4) What Diesel Dave said...exhaust needs to be wide open.

The Minion is a little bit different because the coals are heating to the point of firing underneath the lit ones instead of lighting cold as would happen when throwing them onto a lit bed of coals. That being said, some people do have an issue with the acrid taste even from the Minion method.

Ran a WSM for a long time, and yes you will still want to add lit coals if you need to. The difference will be that you shouldn't need to add coals except in extreme cases because you have a more efficient smoker.

Back to my point # 1...use the right type of wood with your meat. Hickory is not the best wood for poultry.

Apple or other fruit woods is a good choice...other light smoking woods.

Here are my thoughts:
1. Are you using the water pan? If you are, try a cook without water.
2. You should be able to load up your cooker and do a Minion style burn and get several hours before needing to add more fuel.
3. Try a cook without any wood chunks to set a base level, then add 1 chunk each cook until you reach your desired amount of smoke flavor. Keep in mind that different types of meat saturate with smoke differently.
4. Run your cooker for about an hour before you put your meat on. I know this seems like a waste of good fuel, but start here and adjust as your figure out your cooker. I don't put my meat on the smoker until I get that "Thin Blue Smoke" or "TBS" everyone talks about. I frequently get the cooker up to temp way before the TBS sets in.
5. Adding unlit coals is not the same as the Minion Method. When using the Minion Method the unlit coal are heated up and not cold. Cold fuel causes the thick white smoke, thus the reason for waiting for TBS before adding meat to the cooker.
6. You could do just fine with your smoker, a few tweaks and mods here and there and you could have something you can really enjoy. If you are set on a new smoker it is going to depend on your budget. I ended up building a UDS because I couldn't decide on what I wanted to spend my money on and I wasn't sure the type of smoke I wanted to use. I've been using my UDS for over a year now and don't plan or need to upgrade anytime soon.

good luck.

For poultry I use Stubbs only, no wood. It comes out juuuust right!

Bludawg said:

To build on IamMadMan ;Chicken sucks up smoke like a sponge Cut back on the wood If your just doing a bird 1 man fist chunk is more than enough to get the job done. If your not using lump you should really give it a try, It burns much cleaner less chance of over smokin.

Click to expand...

There's your key to success......

You should probably be hotter than 200 to 210.