Pa_BBQ
is one Smokin' Farker
I am getting ready to order the metal, and not sure if I should use 16 gauge and weld it, or 20 gauge and use sheet metal screws to attach the outer skin to my insulated vertical smoker.
Inside will be 1/8" steel with 1" 16 gauge tubing.
Also, if I weld it, do I need to make any vent holes in the bottom tube incase the insulation picks up moisture?
Inside will be 1/8" steel with 1" 16 gauge tubing.
Also, if I weld it, do I need to make any vent holes in the bottom tube incase the insulation picks up moisture?