boatnut
is Blowin Smoke!
Ok, was out in garage measuring stuff. looks like the outside measurement on weber kettle "lip" is 22 5/8". The inside measurement of the drum appears to be 22 1/2". do i just take a cut of blade in my grinder and cut off about an inch of the kettle then slide it down into the drum till it snugs up? do i need to weld it? would like option of using both flat lid as well as kettle lid for hams/turkeys etc. Another option I think I have would be to weld the kettle lid to a spare flat lid then cut out the inside of the flat lid leaving about an inch "flange" all around.
Can anyone chime in???
Can anyone chime in???