Sammy_Shuford
is Blowin Smoke!
Well, it's a bit out of round. I wonder if I squeeze it if I can get it to hold shape?
Anyone else had this problem?
Anyone else had this problem?
UDS top not a circle
- Thread starter Sammy_Shuford
- Start date
-
- Tags
- uds
AustinKnight
is Blowin Smoke!
The top lip of the barrel or the lid, I had both were i had to get pliers and bind the lip out on some sides and I used a brick on the ground and placed my lid center with the brick and pushed down on the sides. That worked for me now it closes down properly to preserve coal.
Sent from my SGH-T959 using Tapatalk
Sent from my SGH-T959 using Tapatalk
Sammy_Shuford
is Blowin Smoke!
Thanks,
BigBobBQ
Babbling Farker
if it is the top of the barrel that is out of round I used a small piece of cable and wrapped it around the top and used a small turnbuckle like thing to tighten it down and it pulled it back to a round shape.
ssbbqguy
is one Smokin' Farker
Just lay it on it's side and gently push on a soft surface. I check every one I assemble for roundness and it's a common problem. It will affect temp. variences and should be round. Steve.
