The BBQ BRETHREN FORUMS.  



Our Homepage Donation to Forum Overhead Recipes Smoke Signals Magazine Welocme Merchandise Associations Purchase Subscription Amazon Affiliate
Go Back   The BBQ BRETHREN FORUMS. > Discussion Area > Q-talk

Notices

Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, equipment and outdoor cookin' . ** Other cooking techniques are welcomed for when your cookin' in the kitchen. Post your hints, tips, tricks & techniques, success, failures, but stay on topic and watch for that hijacking.


Reply
 
Thread Tools
Old 09-01-2013, 09:49 PM   #1
BASSER
Full Fledged Farker
 
Join Date: 08-04-13
Location: Dayton, Ohio
Default Blue Smoke

When I start up my WSM using the Minion Method I bury my hardwood chunks in the charcoal. As the WSM gets up to temp, the chunks are producing white smoke. Is this NOT the time to put on the meat? Do I wait until I dont see any smoke at all to put the meat on? If I do wait, does this not defeat the purpose of using the hardwood chunks. I know this sounds like BBQ 101 but I truly dont know. I just always put the meat on once the desired temp was reached regardless if white smoke was coming out. Thanks Brethren.
__________________
Rob

WSM 18.5", Weber Kettle, Thermapen, Maverick ET-732
BASSER is offline   Reply With Quote




Old 09-01-2013, 10:29 PM   #2
marubozo
is one Smokin' Farker
 
Join Date: 06-25-11
Location: SW Michigan
Default

Don't put the meat on with thick white smoke. Over time as it burns down you will see the thick smoke start to thin, and eventually be a very thin and faint blue. Not long after that you may not see any visible smoke really at all. Don't worry, your meat is still getting smoke flavor.

On a WSM using minion like you are, it isn't uncommon for the smoke to take upwards of an hour to settle down before it's ready.
marubozo is offline   Reply With Quote


Thanks from:--->
Old 09-01-2013, 10:38 PM   #3
SmittyJonz
somebody shut me the fark up.
 
SmittyJonz's Avatar
 
Join Date: 07-17-13
Location: Burleson Tx
Default

Depends on ur charcoal - Alot of briquettes will put out white smoke whole time.......
SmittyJonz is online now   Reply With Quote


Thanks from:--->
Old 09-01-2013, 11:00 PM   #4
retired trucker
is One Chatty Farker
 
Join Date: 09-28-11
Location: Dallas, Georgia
Default

If the briquets are not completely dry (an open bag that has sat around in an UN-controlled area can absorb moisture better than a sponge) they will smoke sometimes for the entire cook. Usually this small amount of smoke is harmless as far as my experience has been. Using damp or un-seasoned wood will make smoke and creosote every time.

Blessings,
Omar
__________________
Webber 22 1/2 OTG Gold, UDS, rusted out chimney, Red Lavatools Thermowand, Maverick ET 732, 1950 model wife. Walking cane to help me get around.
retired trucker is offline   Reply With Quote


Thanks from:--->
Old 09-02-2013, 07:22 AM   #5
stargate823
On the road to being a farker
 
Join Date: 03-07-13
Location: Edgewood, MD
Default

Here is a tip I learned recently that has completely changed the quality of my smoke. Instead of burying a mess of wood in the coals, wrap a few chunks in foil and make a few slashes in the foil on all sides. What this does is it starves the wood of oxygen allowing it to smolder instead of burn. When your pit comes up to temp, throw your meat on and add a chuck of your foiled wood on top of the hot coals. Add the next one after a half hour or so and a third if needed. My wood usage has dropped dramatically and I get thin blue smoke every single time!
stargate823 is offline   Reply With Quote


Thanks from:--->
Old 09-02-2013, 07:40 AM   #6
Kloogee
Full Fledged Farker
 
Kloogee's Avatar
 
Join Date: 09-05-12
Location: Midwest
Default

I don't remember who originally posted this picture, but I thought it was a great illustration of the difference of bad vs.good smoke.



Of course the picture is of an offset, not a WSM like you have, but the smoke is still the same. Good luck with your cook!
Kloogee is offline   Reply With Quote


Thanks from:--->
Old 09-02-2013, 07:54 AM   #7
IamMadMan
somebody shut me the fark up.

 
IamMadMan's Avatar
 
Join Date: 07-30-11
Location: Pemberton, New Jersey
Default

The white smoke/blue smoke issue doesn't really occur with charcoal; it occurs with the added wood to charcoal for smoke flavoring. Charcoal is a wood product created by heating away most of the moisture, resin, and other impurities leaving mostly carbon. This is why a piece of lump charcoal weights less than the same size piece of wood, and why it burns so much cleaner than wood.

Some charcoals have additives to make them burn more consistent, and then with smokers with water pans; vapor can be misconstrued as white smoke. Some charcoals can absorb moisture if they are stored in an outside location. This type of smoke is mostly moisture escaping from the cooker and probably is not from poor combustion.

The simple way is to tell is to follow your sense of smell. Bad smoke is overpowering and smells bad. Good smoke smells good and not overpowering.

Sweet blue can be seen even when it's "invisible" but you have to get the right angle of light on it. It's very thin, and wispy, and almost invisible.

Follow your nose rather than your eyes.
IamMadMan is online now   Reply With Quote


Thanks from:--->
Old 09-02-2013, 08:22 AM   #8
BASSER
Full Fledged Farker
 
Join Date: 08-04-13
Location: Dayton, Ohio
Default

Thanks for all the responses. You guys are great!
__________________
Rob

WSM 18.5", Weber Kettle, Thermapen, Maverick ET-732
BASSER is offline   Reply With Quote


Old 09-02-2013, 08:28 AM   #9
LMAJ
somebody shut me the fark up.

 
LMAJ's Avatar
 
Join Date: 07-01-07
Location: Southeastern Pa
Default

You don't need to see the smoke. you just need to smell it.
__________________
L-M
Official Pennsylvania MOINK Ball maker
1 Large BGE - 7/5/08
1 Large BGE and table - 8/29/12
1300 Timberline 5/26/17
1 18.5 WSM
Super Fast BLUE and REDThermopen
1 - Fantastic hubby - the original Big Al
Enjoy the little things, for one day you may look back and realize they were the big things. - Robert Brault
LMAJ is offline   Reply With Quote


Thanks from:--->
Old 09-02-2013, 08:45 AM   #10
slackdogbbq
Full Fledged Farker
 
Join Date: 07-09-09
Location: Loxahatchee, FL
Default

You said "bury my hardwood". Ha! Sorry, could not resist.
slackdogbbq is offline   Reply With Quote


Thanks from:--->
Old 09-02-2013, 09:18 AM   #11
Bonewagon
Babbling Farker

 
Join Date: 06-12-09
Location: Ithaca, Michigan
Default

Quote:
Originally Posted by marubozo View Post
Don't put the meat on with thick white smoke. Over time as it burns down you will see the thick smoke start to thin, and eventually be a very thin and faint blue. Not long after that you may not see any visible smoke really at all. Don't worry, your meat is still getting smoke flavor.

On a WSM using minion like you are, it isn't uncommon for the smoke to take upwards of an hour to settle down before it's ready.

Spot on advice.
__________________
Jason

Big Steel Keg, WSM, OTG, PBC, Kamado Joe Jr., Carson Rodizio, and a Super Fast and Accurate Blue Splash-Proof Thermapen
Bonewagon is offline   Reply With Quote


Thanks from:--->
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Forum Custom Search: Enter your Search text below. GOOGLE will search ONLY the BBQ Brethren Forum.
Custom search MAY not work(no display box) in some configurations of Internet Explorer. Please use compliant version of Firefox or Chrome.







All times are GMT -5. The time now is 06:40 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.
no new posts