The BBQ BRETHREN FORUMS.


Forum Portal Recipes Smoke Signals Magazine Welocme Merchandise Associations Purchase Subscription Brethren Banners
Go Back   The BBQ BRETHREN FORUMS. > Discussion Area > Q-talk

Notices

Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, Equipment and just outdoor cookin' in general, hints, tips, tricks & techniques, success, failures... but stay on topic. And watch for that hijacking.


Reply
Thread Tools
Unread 07-08-2013, 12:33 PM   #16
hominamad
Knows what a fatty is.
 
Join Date: 07-12-10
Location: New York
Downloads: 0
Uploads: 0
Default

Wanted to give an update. This weekend I went to see both the Akorn and the Visions Classic in person. I think I'm actually leaning more towards the Akorn now. I saw what oldhoss was referring to. Even though the Visions is ceramic, it didn't seem as well put together as the Akorn (although the Akorn had a slightly cheap feel to it as well, I was expecting that given its price).

I like the grate setup better on the Akorn and also liked the swiveling second level grate they have. Also having the inside lip to hold another grate on the inside was a huge plus for me. Also liked how the ash catcher removes on the Akorn - but hopefully this doesn't come with a price in air leaks.

Think I will probably pull the trigger on this sooner rather than later. I figure I can try out Kamado cooking for a few years with this at a small price, and maybe down the line will upgrade to a BGE if I seem to be getting a lot of use out of it.

Meanwhile, I cooked up some amazing pecan smoked chicken thighs and seared ribeye at the same time on my OTS this weekend. Wondering if I would have used the Kamado for this if I had it......
hominamad is offline   Reply With Quote


Unread 07-08-2013, 01:19 PM   #17
ICDEDTURKES
On the road to being a farker
 
Join Date: 06-12-13
Location: McBain, MI
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by hominamad View Post
Also liked how the ash catcher removes on the Akorn - but hopefully this doesn't come with a price in air leaks.

.
From my experience I think it can.. Last year I had the factory gasket on the bottom of main part of cooker and BGE felt on top of ash pan. Sometimes my cooks would go in streaks 3-4 great low and slow cooks pegging temp.. Than I may have 2-3 in a row that it wanted to creep.. I than noticed it was when I was dumping ash and I would have to assume the seal between the two gaskets when put on determined it..

I smoked my factory lower gasket this winter and BGE felt through stupidity.. Replaced both with Nomex and this thing has been rock solid.. Seeings that it has been rock solid I have been using a shop vac from the top to clean up the ash without removing the ashpan.. Their has been zero variability in my ability to control temps cook to cook..
ICDEDTURKES is offline   Reply With Quote


Unread 07-08-2013, 01:31 PM   #18
NYCQ
Is lookin for wood to cook with.
 
Join Date: 06-13-12
Location: STATEN ISLAND
Downloads: 0
Uploads: 0
Default

Since you already have a kettle then it doesn't make that much sense to get the Performer as it's essentially the same cooking unit.

I'd reconsider the WSM as it's amazing for smoking and you have the kettle already for grilling
NYCQ is offline   Reply With Quote


Unread 07-08-2013, 02:02 PM   #19
Smoking Terrapin
Knows what a fatty is.
 
Join Date: 07-02-12
Location: Walkersville, MD
Downloads: 0
Uploads: 0
Default

Akorn. No doubt about it. It is far more versatile and will hold temp longer than any kettle or WSM. I still prefer my offset for longer, low temperature cooks, but this is more than adequate. Some Home Depots carry an Akorn (apparently down South) with a table set-up similar to the performer. If you found one of those, it should be a no-brainier!
Smoking Terrapin is offline   Reply With Quote


Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Loading



All times are GMT -5. The time now is 10:26 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vBulletin Optimisation provided by vB Optimise v2.6.0 Beta 4 (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.
no new posts