喂我西摩
The BBQ BRETHREN FORUMS.  


Our Homepage Recipes Smoke Signals Magazine Welocme Merchandise Associations Purchase Subscription Brethren Banners(temp offline)
Go Back   The BBQ BRETHREN FORUMS. > Discussion Area > Q-talk

Notices

Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, Equipment and just outdoor cookin' in general, hints, tips, tricks & techniques, success, failures... but stay on topic. And watch for that hijacking.


Reply
 
Thread Tools
Old 06-11-2013, 12:43 AM   #16
Bob Wiley
is one Smokin' Farker
 
Join Date: 01-04-10
Location: Indianapolis, IN
Default

I'm in the minority here. Run it with water. Makes a great govoner on temps.
Full charcoal ring with scattered wood chunks. Dump a 1/2 chimney of lit coals on top. Start with lower vents 1/2 open. when it gets to 225 close down to 1/4 to 1/8 open. It will hold 225 all day. Charcoal is cheap. Make it easy on yourself.
Bob Wiley is offline   Reply With Quote


Old 06-11-2013, 09:25 AM   #17
HankB
is One Chatty Farker
 
Join Date: 01-16-12
Location: Winfield, IL
Default

Quote:
Originally Posted by Wingnutt View Post
I was also considering picking up come high temp silicone and applying a thin bead around where the door seals as well as the lower ring to help seal up any air leaks. Any experience with this? Or don't bother?
I did that on the bottom edge of my 18.5 WSM.



It meant that I could close all of the vents and the coals would go out so I'm happy with that mod. I didn't bother with the door.

Of course I followed other recommendations as well like making sure that the middle section was as round as I could make it and fitting the door to minimize the gap. I also rotate the middle section on the base until the gap looks even all of the way around.

I don't feel like I'm fighting anything. I can easily dial in temps anywhere from about 200°F to 350°F.
__________________
Weber Crazy
HankB is offline   Reply With Quote


1 members found this post helpful.
Thanks from:--->
Old 06-11-2013, 09:44 AM   #18
rpg421
Wandering around with a bag of matchlight, looking for a match.
 
Join Date: 06-10-13
Location: AUSTIN
Default

Has anyone used the snake or fuse method in the 22.5 charcoal set up?
rpg421 is offline   Reply With Quote


Old 06-11-2013, 11:47 AM   #19
frankH
On the road to being a farker
 
Join Date: 02-25-12
Location: Overland Park, KS
Default

Without water in the pan, I could never get the temp to drop without poring water on part of the coals. With water in the pan, the temp will gradually drop with the vents shut.

Also, if you spray some vegetable oil around the seams, it speeds up the seasoning process.
frankH is offline   Reply With Quote


Old 06-11-2013, 12:15 PM   #20
Harbormaster
somebody shut me the fark up.
 
Harbormaster's Avatar
 
Join Date: 07-14-06
Location: Wyocena/Pardeeville, WI
Default

Quote:
Originally Posted by rpg421 View Post
Has anyone used the snake or fuse method in the 22.5 charcoal set up?
That's sort of what the Minion Method is. Lit coals are added to a localized are of unlit and the fire spreads through the rest of the fuel at a gradual rate.
__________________
Clark
My Boys: Joseph (EI); Andrew (EE); Daniel (EE)
My Toys: 10 WSMs (B, C, E, DH, DA, EZ, DZ, EO, DU, DR); 5 - 22.5" Bar-B-Q-Kettles; 2 - 18.5" Bar-B-Q-Kettle; 4 WGAs (EZ, DE, N, B); 2 SJPs ( DR, DR); 2 Smokey Joes (A, K); Genesis Silver C (DU);
Brinkman Cimmaron.
"For when democracy becomes tyranny, those of us with rifles still get to vote"
Harbormaster is offline   Reply With Quote


Old 06-11-2013, 12:20 PM   #21
Texas Turtle
Take a breath!

 
Join Date: 05-26-09
Location: Fulshear, Texas
Default

I usually just dump about a half chimney of lit coals on top of the filled ring, but last time I thought I'd get cute, so I sat the chimney in the center of the ring and poured the KBB around it. Then I put about a half chimney in and lifted the starter out, leaving a nice round hole in the middle. Lit the coals in the chimney and carefully poured them into the donut hole. For some reason it didn't seem to work as well as the old method. Temps came up slower than usual and I ran out of fuel at about the 7 hour mark and had to refuel to finish the butts. I'm going back to the old way.
__________________
BBQ Apprentice - Old Country Brazos offset, 22.5 WSM, Various gassers, portable grills, etc.
Texas Turtle is offline   Reply With Quote


Old 06-11-2013, 12:22 PM   #22
Cayman1
is one Smokin' Farker
 
Join Date: 07-20-12
Location: Springfield, MO
Default

I did trout last night. It ran at 200, no problem. I used water in the pan and only 12 lit coals to start it, lump for the cook. In fact, I had to open the bottom vents just a little to maintain the 200. Water makes a tremendous difference.
__________________
Smooth Smoke BBQ Team, KCBS CBJ, porch mounted Jambo.
Cayman1 is offline   Reply With Quote


Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Forum Custom Search: Enter your Search text below. GOOGLE will search ONLY the BBQ Brethren Forum.





All times are GMT -5. The time now is 11:38 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.
no new posts