N
Nerd
Guest
Brothers,
I'm making new wood parts for my Father-in-law's old Weber Genesis 1000 as a Christmas gift. He loves that grill, but the wood parts are looking worse for wear. I measured the dimensions for most of the pieces on my own 1000, but mine was purchased 2nd hand without the swing up work table, so I don't have dimensions for it.
I would be forever grateful if one of you could measure the length of the slats on your swing up work table and post them here so I can make them correctly. The table looks to be the same on both the 1000 and 1100.
Sadly, time is of the essence as I would like to have them largely completed before he arrives in two days to avoid making up excuses for long absences in the garage while he's here.
Gratefully Yours,
Sean
I'm making new wood parts for my Father-in-law's old Weber Genesis 1000 as a Christmas gift. He loves that grill, but the wood parts are looking worse for wear. I measured the dimensions for most of the pieces on my own 1000, but mine was purchased 2nd hand without the swing up work table, so I don't have dimensions for it.
I would be forever grateful if one of you could measure the length of the slats on your swing up work table and post them here so I can make them correctly. The table looks to be the same on both the 1000 and 1100.
Sadly, time is of the essence as I would like to have them largely completed before he arrives in two days to avoid making up excuses for long absences in the garage while he's here.
Gratefully Yours,
Sean