ブタ
The BBQ BRETHREN FORUMS.


Forum Portal Recipes Smoke Signals Magazine Welocme Merchandise Associations Purchase Subscription Brethren Banners
Go Back   The BBQ BRETHREN FORUMS. > Discussion Area > Q-talk

Notices

Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, Equipment and just outdoor cookin' in general, hints, tips, tricks & techniques, success, failures... but stay on topic. And watch for that hijacking.


Reply
Thread Tools
Unread 10-10-2012, 04:15 PM   #1
Av8tor
Found some matches.
 
Join Date: 07-25-12
Location: Northwest Arkansas
Downloads: 0
Uploads: 0
Default Akron Temp Control Issue

Hey all I wanted to throw this out there in case someone else out there was having the same issue that I have been having cooking on my Akron Komodo. In short no matter how I adjusted my vents I could not maintain any temperature range without adjusting the vents every few minutes. So I set out to do some trial runs to learn how to do it. My goal is to be able to maintain a 20 degree range with little effort.

After a few runs using RO Lump (with no wood chunks) I was still having the same problem, unable to maintain a temperature steady within 20 degrees.

So, I took a step back and thought backward about it for a minute and then it finally dawned on me. I am using to much lump!

I shut it down and started my final run of the day. Step 1 was to completely clean out the ash pan. Step 2 was to light my chimney 3/4 full with lump. Once it was ready I dumped it in closed the lid and set my vents to just slightly open. My temperature ran up to 280 and stabilized.

I am no longer seeing large temperature swings. It appears I may have found the answer, but I will reserve final judgement until I see how long I can maintain my range without changing my vent settings.

Last edited by Av8tor; 10-10-2012 at 04:32 PM..
Av8tor is offline   Reply With Quote


Unread 10-10-2012, 04:29 PM   #2
El Ropo
Babbling Farker
 
El Ropo's Avatar
 
Join Date: 10-06-10
Location: Austin, TX
Downloads: 1
Uploads: 0
Default

I'm thinking even starting with 3/4 chimney of lit lump is more than I would need to get an Akorn stable at any temp. These are highly efficient and don't need a lot to get going.

Catch the temps on the way up, start closing down intake before target temp is reached. If you overshoot, it's hard to bring down temp in an insulated cooker.
__________________
Modded Brinkmann Gourmet. Basic UDS. Rescued 22.5" OTS. SJS Mini-WSM. Stubbs. B&B Oak Lump.

Cannondale 2009 F8 (for burning off all the great BBQ)
El Ropo is online now   Reply With Quote


Unread 10-10-2012, 04:32 PM   #3
superdan
Full Fledged Farker
 
Join Date: 08-21-11
Location: Sacramento, CA
Downloads: 0
Uploads: 0
Default

I use the tips talked about before on some thread - I put a pile of lump in then oil some dryer lint and light it in my lump pile. Very little fire required to keep the temps. I also think lighting 3/4 a chimney is a bit much...
superdan is offline   Reply With Quote


Unread 10-10-2012, 04:44 PM   #4
chriscw81
is One Chatty Farker
 
Join Date: 07-01-12
Location: Fredericksburg, VA
Downloads: 4
Uploads: 0
Default

el ropo and superdan are right. i use a type of minion method to light my akorn where my lump is piled up kind of like a small volcano and i use half of a weber starter cube to light one piece of lump on top. i start closing down the vents at about 160 and it's not hard to park it at 250-275. the akorn tends to want to run hotter than the popular 225(225 is not required imho btw) but i like to let it because i'm more interested in a fire that's burning efficiently than being choked out. if you havent already check out the akorn section on the kamadoguru forum or jmsetzler has a ton of youtube videos about this grill. here is a link to the method i use to start my akorn and it works great. hopefully this helps and i havent rambled on too much

http://kamadoguru.com/viewtopic.php?f=22&t=637
__________________
[B][I][COLOR=black]*A Texan transplant*[/COLOR][/I][/B]

[B][SIZE=1][COLOR=black]UDS | [COLOR=blue]Blue[/COLOR] Weber Performer Platinum | Chargriller Akorn | 22.5 Weber OTG | WSJ Gold | Mini WSM | Maverick ET-73 | [COLOR=blue]Blue [/COLOR][COLOR=black]Thermapen | Maverick PT-100 |[/COLOR] Gasser(charcoal chimney starter)[/COLOR][/SIZE][/B]
chriscw81 is offline   Reply With Quote


Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Loading



All times are GMT -5. The time now is 08:23 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vBulletin Optimisation provided by vB Optimise v2.6.0 Beta 4 (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.
no new posts