The BBQ BRETHREN FORUMS.


Forum Portal Recipes Smoke Signals Magazine Welocme Merchandise Associations Purchase Subscription Brethren Banners
Go Back   The BBQ BRETHREN FORUMS. > Discussion Area > Q-talk

Notices

Q-talk *ON TOPIC ONLY* QUALITY ON TOPIC discussion of Backyard BBQ, grilling, Equipment and just outdoor cookin' in general, hints, tips, tricks & techniques, success, failures... but stay on topic. And watch for that hijacking.


Reply
Thread Tools
Unread 09-19-2012, 07:49 AM   #1
ccarter
Full Fledged Farker

 
Join Date: 07-05-12
Location: Acworth, GA
Downloads: 0
Uploads: 0
Question How long can a brisket rest?

I picked up a 15lb brisket yesterday to smoke (yesterday was my Saturday), and realized that it could take a long time to smoke at 245*. I put it into the smoker at 9:15 last night, allowing it to have 18 hours in the smoker before I the time I want to pull it (this afternoon at 3:30pm). It's 9am, the brisket has been in for 12 hours, and it at 195* internal (according to a stoker probe). Only 1 out of 4 spots on the flat probed tender, but the whole point was tender. I took the brisket out, seperated the point and flat, cubed the point for burnt ends, and put everything back in the smoker. I'm going to start probing every 45 mins or so, but I'm not expecting the flat to take more than about 2 more hours.

This brisket is for dinner tonight. I wanted to pull at 3:30pm, and give it 3 hours to rest before slicing. If it makes it another 2 hours it'll only be 11am, so I'll need to make the brisket keep for about 7 hours before time to slice. I've got one of the newer "stacker" coolers that's a perfect size for resting meats, and a bunch of towels. That's how I plan to rest it.

Will it rest for 7 hours?

Are there any alternatives?

I closed up the intake vents to drop the smoker temp. I'm shooting for 225*, and may take it a little lower to keep the flat warm.

Is warming it in the smoker a bad idea?
__________________
18.5" WSM, Large BGE, Backwoods Party
Blue BBQGuru DigiQ DX2
Blue Superfast Thermapen
ccarter is offline   Reply With Quote


Unread 09-19-2012, 07:54 AM   #2
CarolinaQue
is Blowin Smoke!
 
Join Date: 06-23-07
Location: North Berwick, ME
Downloads: 0
Uploads: 0
Default

Well, you can wrap it in foil, then newspaper and then a towel and place in the cooler with the rest of the air space in the cooler filled with towels over the brisket and you would likely be fine. I would preheat the cooler by pouring some very hot water into it and closing it up for 30 minutes or so, dump the water and then put the brisket in it.

If you get really concerned, hold it this way for 4 hours or so and then put it into a 200* oven (after you take the towel and newspaper off of it), for the remaining time, taking it out 30 minutes or so before needing to slice.
__________________
Tim

[COLOR=darkred]“Travel is fatal to prejudice, bigotry, and narrow-mindedness, and many of our people need it sorely on these accounts.”[/COLOR] - Mark Twain

- Beautiful family
- Home made trailer mounted reverse flow offset w/ vertical chamber, Weber OTG and an ECB
CarolinaQue is offline   Reply With Quote


Thanks from: --->
Unread 09-19-2012, 08:46 AM   #3
mr dirts bbq
Full Fledged Farker

 
mr dirts bbq's Avatar
 
Join Date: 01-24-12
Location: yorktown, new york
Downloads: 0
Uploads: 0
Default

ive never rested that long, maybe 4 hours max.... i would kinda agree with CQ, i would hold in cooler for 5 hours put in oven at 200 till 1 hour before serving rest 45 then slice,
it wont be the best brisket situation IMO but it should work. as long as the internal temp stays up
__________________
charbroil offset, custom trailer pit, 46" vermont castings gasser, 18" kettle, big poppa smokers engineered drum kit smoker than was never picked up = NEW TOY! and last but not least: a never ending 20' comp trailer project
mr dirts bbq is offline   Reply With Quote


Thanks from:--->
Unread 09-19-2012, 08:53 AM   #4
Panthers65
is one Smokin' Farker
 
Join Date: 07-13-09
Location: Lilburn, GA
Downloads: 0
Uploads: 0
Default

put a thermometer in it and put it in the cooler. As long as it's above 145* you're good. If it gets too low too soon, put it in the oven.
Panthers65 is offline   Reply With Quote


Thanks from:--->
Unread 09-19-2012, 09:20 AM   #5
grantw
Full Fledged Farker
 
Join Date: 09-13-12
Location: canada
Downloads: 3
Uploads: 0
Default

To gain some time you could also Take it off the smoker, kill the air to the fire, return it to the smoker, let it start to rest while the temp slowly drops, pre warm a cooler and put in in there. That should give it lots of rest time
__________________
Backwoods party,22.5 wsm,18.5 wsm,14.5 wsm, smokey joe, performer,22.5 kettle.
grantw is offline   Reply With Quote


Thanks from:--->
Unread 09-19-2012, 10:01 AM   #6
Ron_L
Moderator

 
Ron_L's Avatar
 
Join Date: 12-09-04
Location: Chicago 'Burbs
Downloads: 1
Uploads: 0
Default

I've gone 6 hours with a preheated cooler and a lot of towels. If you have a remote thermometer you can stick a probe in it and watch the temp. If it starts to get close to 140 then pop it in a warm oven.
__________________
"Ron Rico, Boss. You can call me Captain Ron..."

Unwrap me!
Smoke me!
Eat me!

The Naked Fatty!

FEC-100/BWS Party/Memphis Pro SS/PBC/LBGE X 2/SBGE/Mini BGE/Nomad Pellet-matic/Good-One Model 42/WSM X 2/Cookshack Smokette 008/Weber Performer/Saber Cast 500/Weber Gasser (RIP)/Weber Kettle X 2/Weber Smokey Joe/WGA/UDS/Coffee Roasting Gasser

Remembering a friend
Ron_L is online now   Reply With Quote


Thanks from:--->
Unread 09-19-2012, 11:57 AM   #7
ccarter
Full Fledged Farker

 
Join Date: 07-05-12
Location: Acworth, GA
Downloads: 0
Uploads: 0
Default

I just took it off the smoker at 12:30 (3 hours earlier than I really wanted to). That means it will need to sit for about 6 hours. I've got it nicely wrapped up in the cooler at the moment, and I'm going to check it at 4pm. If it needs some love, I'll throw it in the oven at about 200* in the foil with a little bit of beef broth to help with moisture.

Thank you everyone for the suggestions! We'll see how this goes.
__________________
18.5" WSM, Large BGE, Backwoods Party
Blue BBQGuru DigiQ DX2
Blue Superfast Thermapen
ccarter is offline   Reply With Quote


Unread 09-19-2012, 12:15 PM   #8
sdbbq1234
is one Smokin' Farker

 
sdbbq1234's Avatar
 
Join Date: 02-11-10
Location: Northern VA
Downloads: 1
Uploads: 0
Default

If it is probe tender, I would put in oven at 170 (I think that is the lowest ovens will go). Any higher, and you are going to cook it too much and dry it out.

My 2 cents worth.

wallace
__________________
- Life Is Good, But BBQ Is Better!
- BWS - Fat Boy
- WSM 22.5
- A bunch on other outdoor cooking stuff.
- KCBS CBJ# 58657
- MABA Member

"Take luck!"
sdbbq1234 is online now   Reply With Quote


Thanks from:--->
Reply

Tags
backwoods, brisket, BWS, flat, Party, Rest

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Loading



All times are GMT -5. The time now is 05:29 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vBulletin Optimisation provided by vB Optimise v2.6.0 Beta 4 (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.
no new posts