Cuebie
Knows what a fatty is.
I've got a Weber OTG, so far the OEM hood thermo is accurate (at least at 212f) but with dual zone cooking, I'm curious what the grate temp is.
I've seen some mods where guys will drill and add a silicone grommet & a probe. Where can you get these grommets? Is this the best way? What's the best kind of bit to use to drill the kettle? I'm totally willing to drill the OTG, I just want to make sure this is the best method before I go putting holes in it...
Any suggestions?
Thanks for all your replies, you guys have been very gracious offering up good tips!
Best,
Ian H.
I've seen some mods where guys will drill and add a silicone grommet & a probe. Where can you get these grommets? Is this the best way? What's the best kind of bit to use to drill the kettle? I'm totally willing to drill the OTG, I just want to make sure this is the best method before I go putting holes in it...
Any suggestions?
Thanks for all your replies, you guys have been very gracious offering up good tips!
Best,
Ian H.