View Single Post
Old 03-21-2010, 10:09 AM   #5665
Pole D
is one Smokin' Farker
 
Join Date: 09-06-09
Location: Cary, NC
Default

Quote:
Originally Posted by Mextra55 View Post
This thread has be great , i am pretty much done making the UDS but does anyone have a good tips on screwing the conduit rings down tighter ?they just get stuck on the nipple thread after a few turns . I thought about taking the Dremel to it to open it up a lil
I only used the nipple on the hole with the ball valve. The other holes I just used magnets on.

Anyhow the one nipple I used went in so tight that I just skipped using the conduit nuts. I didn't need them.
Pole D is offline   Reply With Quote