HeSmellsLikeSmoke
somebody shut me the fark up.
First, my thanks to all the great contributions of the Brethren and Sistren in the UDS Thread. My goal was to use best ideas I saw to produce a very simple stainless UDS.
This has a Weber Performer Lid with the built-in thermostat and the stainless draft door from Big Green Egg.
Removable lid seal insert made from old Bar-B-Kettle bottom cut to leave 2" w/ Rutland stove gasket attached to it with high-temp silicon.
(Trial run last night was a 14 lb brisket packer, cooked at 300 degrees until probe tender in 5 1/2 hours. Outdoor temperature was low 20's w/ snow showers. Cooked it Lockhart style with outstanding results -- thank you Funk for all the great info you have shared.)
I am going to add handles, but not much more. I like the simplicity.
This has a Weber Performer Lid with the built-in thermostat and the stainless draft door from Big Green Egg.
Removable lid seal insert made from old Bar-B-Kettle bottom cut to leave 2" w/ Rutland stove gasket attached to it with high-temp silicon.
(Trial run last night was a 14 lb brisket packer, cooked at 300 degrees until probe tender in 5 1/2 hours. Outdoor temperature was low 20's w/ snow showers. Cooked it Lockhart style with outstanding results -- thank you Funk for all the great info you have shared.)
I am going to add handles, but not much more. I like the simplicity.