BarberQue
Full Fledged Farker
- Joined
- Nov 15, 2008
- Location
- Dearborn...
I just want to say thanks to all the veterans out there that keep relentlessly leading us toward the light!:eusa_clap:eusa_clap
Hey guys. I have a question.
So I picked up a drum this afternoon. This whole time I was planning on picking up an open-head drum. When I got there, I realized that the drums there were closed-head. When I read through this thread, I never really planned on a closed head drum so I never sought out advice on removing it.
You should find another source for drums in your area.
Neighbor. :biggrin:
You should find another source for drums in your area.
Neighbor. :biggrin:
I think you should have a door for those wiered and unscheduled events.
It should be the size of the largeste log you want to use.
Steve out:razz:
I think you should have a door for those wiered and unscheduled events.
It should be the size of the largeste log you want to use.
Steve out:razz:
Hey Bubba, The wife wants to know why there now is 5 barrels in the garage, I told her theeeyy....must have mated:biggrin:
Matter of preference. Valve works for me. If they are clean 1" holes 3/4" nipples screw in and can be welded or locked in with conduit nuts. Someone didn't read whole thead.Ok, I have 2 UDS and I went real cheap and drilled 4 - 1" holes about 3" up from the bottom. I have an OK time with keeping the temp where I want it, but I was wondering if I can improve it by installing a valve? Also if the you think I should go with a valve, how hard would it be to do considering my current hole setup?
Matter of preference. Valve works for me. If they are clean 1" holes 3/4" nipples screw in and can be welded or locked in with conduit nuts. Someone didn't read whole thead.
Close pipe nipples with caps. Valve partial and one cap off gets 250 ish for me. 2 caps off, partial valve gets 375 ish. Fine tune with valve. Make sense?I realize I can easily put in a valve.... I should have been more specific. I would rather not put in 4 valves since I would never use that many. What do I do with the other holes is my question?
Close pipe nipples with caps. Valve partial and one cap off gets 250 ish for me. 2 caps off, partial valve gets 375 ish. Fine tune with valve. Make sense?
Close pipe nipples with caps. Valve partial and one cap off gets 250 ish for me. 2 caps off, partial valve gets 375 ish. Fine tune with valve. Make sense?
Farking numbers are hard to read sometimes.I ended up with an extra hole, think it was about an inch and an eighth.
Greenlee screwup Mod.
Nice weedburner. Will save some knuckle hair. Harbor Freights are too short.