T
Thirsty4Q
Guest
Anxiously awaiting these results! Last thing I need to do before my UDS is up and running. Planned on taking an orbital with 40 grit to the lid tonight.
My fingers are crossed with you! :clap2:
UDS: Oven Cleaner and the Red Lining of DOOM!
- Thread starter PorkDork
- Start date
My fingers are crossed with you! :clap2:
PorkDork
Knows what a fatty is.
I just noticed it says "safer" haha!
"It will still kill ya dead, but it's SAFER than rat poison!"
"It will still kill ya dead, but it's SAFER than rat poison!"
PorkDork
Knows what a fatty is.
I tried a wire wheel and a drill and it took me a good 2 hours to do about 1/8 of the barrel... I REALLY hope this works.
PorkDork
Knows what a fatty is.
UPDATE: The stripper has been at it for about 20 hours now and if anything, it HELPS remove a couple layers of the red epoxy, but there is still a TON of labor still to clean it off, then wire wheel it off. I can say that it is deffinetely easieer to wire wheel the epoxy off after the stripper, but I'm going to have to say Citristrip is busted. No dice, unfortunately.
