Norcoredneck
somebody shut me the fark up.
WD-40, toothbrush wire brush followed by strong tide/warm water mix wash.This lid left quite a bit of the sticky chit behind when I scraped out the foam seal.
WD-40, toothbrush wire brush followed by strong tide/warm water mix wash.This lid left quite a bit of the sticky chit behind when I scraped out the foam seal.
J/K Jerry, mine usually come out clean but i have taken a small torch and burned the glue off one. :biggrin:
WD-40, toothbrush wire brush followed by strong tide/warm water mix wash.
you forgot to do that to mine, eh :biggrin:
Bubba sorry. :roll:
Last minute mod.
ain't nuthin bob marley the weed burner won't fix :biggrin:
Hey Norco the wd40 did the trick with the leftover glue in the lid rim. Let it sit about an hour then hit it with the toothbrush size wirebrush and a little steel wool, cleaned out with Tide solution, rinsed and done. Thank you very much. Somehow that should be added to How a Redneck would build a UDS thread.
Looks cool but bet you won't have enough exhaust. Adapt some fishtails on the Harley Drum using auto header adapters.Now let the comments start!!
Thanks, la smoker
I think DR.Ky made his first from a 30Gal.I have got through about 50 pages of this thread. A lot of good information in here. I have a 30G barrel laying around. My question is, will this work OK for a UDS? I know it will be smaller and might need a water pan. My plan is to use this for a trial run before I find a 55g drum. Any thoughts?
Mike
1" length will do fine, Black Pipe nipples are what they're called and you can use a single conduit nut on the inside and it will work fine.....Guys - I am looking for some details on the intake pipe nipples. How long should they be? 1" long close nipples? Do they need to be stainless? I am not sure what they have over at home deeps, but i doubt its stainless...
Since i am not welding, just to make sure i got this right....I can thread in the 3/4" pipe nipple and on the inside i can lock it down with a conduit nut and same on the outside? I doubt the threading of the ball valve will thread all the way down to the barrel.
Thanks all,
JD
Guys - I am looking for some details on the intake pipe nipples. How long should they be? 1" long close nipples? Do they need to be stainless? I am not sure what they have over at home deeps, but i doubt its stainless...
Since i am not welding, just to make sure i got this right....I can thread in the 3/4" pipe nipple and on the inside i can lock it down with a conduit nut and same on the outside? I doubt the threading of the ball valve will thread all the way down to the barrel.
Thanks all,
JD