Thread
:
If a Redneck wanted to build a UDS
View Single Post
06-05-2008, 09:20 PM
#
1
Norcoredneck
somebody shut me the fark up.
Join Date: 07-11-06
Location: Norco, Ca.
If a Redneck wanted to build a UDS
Ok here is how he would do it. Not that this is the right way or the only way but how I would do it. Will add steps as I complete them.
Divide drum into 3 sections
Layout grill holes.
I chose 1 3/4"" and 8" from top. You should assess the drum you are using.
Layout Intake holes.
I chose 2" from bottom.
Layout Gauge hole.
I chose 9" (1" below lower rack)
Centerpunch marks.
Drill pilot holes.
Drill holes for Intake nipples
I use 1" which lets you thread 3/4" nipple (clean round hole)
Drill out holes for Grate supports
I am going to use 1/4" bolts. I use Unibit to get clean holes in thin metal.
Open up hole for gauge.
I use 3/4" hole which is a tight fit for a 1/2" pipe thread.
Thread in 3/4" close nipples
I use cap to protect threads and screw in as far as possible.
This link will show alternative to welding nipples.
http://www.bbq-brethren.com/forum/sh...2&postcount=40
Weld in Nipples
Install 3/4" ball valve.
__________________
Low
and Slow.....
The Prontologist is in...
Ok let's see your Butt!
Last edited by Norcoredneck; 06-06-2008 at
08:35 PM
..
7 members found this post helpful.
Thanks from: --->
Ag76
,
DBH
,
dddouglas
,
Drunk Monkey
,
Ehudbenjamin
,
GMDGeek
,
Goyo626
,
Smokesome
,
wheelterrapin
Norcoredneck
View Public Profile
Find More Posts by Norcoredneck