View Single Post
Old 04-21-2007, 10:54 AM   #215
Full Fledged Farker
Join Date: 11-22-06
Location: Oklahoma City

Originally Posted by Smokin Gator View Post

I cut the holes to 13/16 and mine thread in pretty tightly. I still thread on conduit nuts and firm the up on the outside. If you need to you could put them on the inside as well.

I bought some 1/2 inch conduit nuts, but the threaded part of the pipe nipple is tapered and the conduit nut will only thread on so far.. it is very thin too and won't snug up to the side of the drum. Do I have the right piece of hardware?

Doing a THIRD burn in my drum today.. picking up a used weber kettle tomorrow for $30. I hope the lid fits on my drum..

I felt I should do a third burn because I still have paint and lettering on the side. I tried burning it off with my propane weed torch, but I think my torch is defective... While i was trying to burn it off, flames started coming out the side of the torch head as much as out the front and the 'blaster' thing doesn't do anything anymore. I had enough flame to light some charcoal, but it took a lot longer.. any ideas on how to fix this torch? I knew I shoulda bought the more expensive one with the igniter. *sigh*

Akorn Komado
GOSM Wide Body
Blutch is offline   Reply With Quote