Quote:
Originally Posted by Wneill20
Fine someone to sand blast it. I did cost me $45. For the inside and out no burning required
|
^^^DO THIS.
Burning it out will barely touch the chit, and even using stripper takes tons of extra elbow grease to get it all out. I spent the better half of a day laying in my drum with a wire wheel on my grinder getting the last of that chit out-mind you this was
after a hot burnout and a stripper treatment too- it farking SUCKED.
I'd gladly pay $50 to get it media blasted if I could do things over.
If only I had a DeLorean...