Forgive me if this is not the place for this... however I couldn't really figure out where it would go.
Ok... I got my hands on an old homemade log splitter that was run by a gasoline engine and hydraulic pump... both were shot... I have access to tractors around here so I was going to convert it to where it hooked to the tractors hydraulics.. The ram moves freely and I got the control box working... but I made a mistake.. I didn't pay attention to where the hoses came from and went when I disassembled it...
Here is a picture I did in Paint with the ports as they are labeled... if anyone has any hydraulic experience... help!