The BBQ BRETHREN FORUMS. - View Single Post - EUDS

Marvin · 05-14-2013, 12:24 AM

Ok, so this is where the fun part starts ... the electrical components.

So in addition to the 220v heating element ...

This is the electrical box that will house the wiring terminal strip, the SSR and it's heat-sink and power cord.

The power cord.

The wall outlet that the cord will plug into.

Here is the SSR (Solid State Relay) mounted on it's heat-sink.

K type Thermocouple (4 inch probe) for PID temperature controller.

The PID ...
Manufacturer: Auber Instruments
Model Num: SYL-2352

Aluminum enclosure for the PID. Will mount this on the side of the barrel.

High heat wire (that you will find in ovens and ranges) to wire from the SSR to the heating element.

05-14-2013, 12:24 AM	#44
Marvin Got Wood. Join Date: 02-12-13 Location: Houston, TX.	Ok, so this is where the fun part starts ... the electrical components. So in addition to the 220v heating element ... This is the electrical box that will house the wiring terminal strip, the SSR and it's heat-sink and power cord. The power cord. The wall outlet that the cord will plug into. Here is the SSR (Solid State Relay) mounted on it's heat-sink. K type Thermocouple (4 inch probe) for PID temperature controller. The PID ... Manufacturer: Auber Instruments Model Num: SYL-2352 Aluminum enclosure for the PID. Will mount this on the side of the barrel. High heat wire (that you will find in ovens and ranges) to wire from the SSR to the heating element.