touchdowntodd
Full Fledged Farker
vERRRRYyy nice!
Thanks ! :thumb:
Those brackets have a lot of hours in them, cut weld, bend and grind. Then add the round stock around each bracket and weld, heat, bend and grind again.
Nice, how much is this costing if you don't mind me asking. Material wise.
Well you got yourself a deal there
Don't really have an accurate tab right now.
I scored on all the beams and the ten sheets of 5/8" plywood from my old place of employment ($350). The cedar ran me around $850 and all the steel brackets were around $250 (my brother works at the steel place). Bolts, nuts and washers were well over a hundred.