View Single Post
Old 12-06-2011, 02:18 PM   #5
Pappy
is Blowin Smoke!
 
Pappy's Avatar
 
Join Date: 05-09-11
Location: Granite City, Illinois (Near St. Louis "GO CARDS")
Default

I like to use a small block of wood with 2 small holes drilled in it. 1st hole is for the chamber temp probe. The other is for the meat probe when the meat is not on the grate yet. I don't like to set the bare meat probe on the hot metal grate so, I put it in the 2nd hole until the UDS is up to temp and ready for the meat. I have a conduit nut where I can run the probes into the UDS and not under the lid. Never cared for the under the lid method.

__________________
22.5 WSM, 120 Gallon Offset, Weber Performer, IQ-110, ET-732

Last edited by Pappy; 12-06-2011 at 02:35 PM..
Pappy is offline   Reply With Quote


Thanks from: --->