Bob in St. Louis
Babbling Farker
- Joined
- Jul 31, 2012
- Messages
- 2,916
- Reaction score
- 20,613
- Points
- 0
- Age
- 54
- Location
- St. Louis Missouri
Last night at 7:30 I put two 8# butts on the WSM, along with 16# of Kingsford.
I set the vents where I normally do and didn't open the lid until this morning at 7:30.
The I.T. was 172 and the dome temp was 125. The fire is all but ashes.
Now...I assume the meat got to proper IT based on 16# of charcoal being consumed. I *think* that's safe to say.
But...the food was sitting there for who knows how long below safe temperature.
I've foiled them both and put them in the oven. I figure I at least need to get them hot enough to burn off any germmies that are present (?)
The meat does seem kinda tough, but it is very juicy. I tried some and it tastes great.
Any ideas or thoughts? Thanks in advance.
I set the vents where I normally do and didn't open the lid until this morning at 7:30.
The I.T. was 172 and the dome temp was 125. The fire is all but ashes.
Now...I assume the meat got to proper IT based on 16# of charcoal being consumed. I *think* that's safe to say.
But...the food was sitting there for who knows how long below safe temperature.
I've foiled them both and put them in the oven. I figure I at least need to get them hot enough to burn off any germmies that are present (?)
The meat does seem kinda tough, but it is very juicy. I tried some and it tastes great.
Any ideas or thoughts? Thanks in advance.