View Single Post
Old 12-07-2017, 10:56 AM   #107
is One Chatty Farker
Join Date: 07-19-13
Location: Houston, TX

My opinion, an offset needs to be 1/4". Less than that requires too much work. It can be done but I think even I would throw in the towel. Sometimes when I'm at Academy I will look at the Old Country smokers. The fit/finish is horrible and the metal is thin. I can see how it would be a lot of work. No way it holds much heat. On my offset the coal bed can be almost gone and it will still be 200*. Thats not going to happen with thin metal. The temp is going to reflect the size of your fire.
Rockinar is offline   Reply With Quote

Thanks from: --->