View Single Post
Old 11-13-2012, 10:29 AM   #6
Untraceable
Babbling Farker
 
Join Date: 05-19-11
Location: EAD
Default

Temp probe is dead in the middle of the top rack

I have the guru adapter on the bottom left of the 4 intake holes and I have questioned that placement as the diverter blows it down but then its almost directly into the charcoal grate. should I have the adapter on the top of the 4 intake holes. I have the other 3 intake holes plugged with sheetmetal plugs. I could just pop one out and switch up the location.

to me the odd thing was just how it was stuck cycling about 13 degrees south of the target. it would cycle 40-50% the temp would climb 2 degrees and then fall back and it would cycle again. in my head I would think it should have been cycling at a higher percentage.
Untraceable is offline   Reply With Quote