Quote:
Originally Posted by MilitantSquatter
I had the other lssue where the top lid was sitting off the bottom (rear) side and it look contstant re-aligning to get it to have minimal gap between gaskets.
|
That's exactly what I saw in the hardware. I ended loosening and readjusting. Worked well and then fired it up for a dry run and lifting and what not it started to move back a little, but not as much. I think the ring is slightly bent, but a minimum of 90% of the gasket is touching at all locations. Can't imagine it will be a problem.
Dry run is humming along pretty well. A little more difficult to run at low temps, but I was expecting that.