View Single Post
Old 07-22-2009, 07:22 PM   #3684
On the road to being a farker
Join Date: 04-04-09
Location: Murfreesboro, TN

Originally Posted by Rich Parker View Post
Nice CL find.

I also have a charcoal bowl sitting around because I used the lid for my UDS. My only concern with using the charcoal bowl as an ash pan is that it will hold the charcoal grate higher than a flat ash pan.
Rich, I am actually going to try to make a charcoal basket out of the 18" Weber bottom, I figure if I cut it off just below where the charcoal grate sits in it I will have a slightly sloped ring about 8" deep by 18" wide. After I cut it off I'll drill probably 50-60 3/4 holes around it for airflow. My biggest concern is that it will be too wide for adequate airflow to the center of it, but the only thing it will cost me is time since I wasn't going to have a use for an 18" bottom for anything else. I still need to figure out exactly how I'm going to raise it above the ash pan but the charcoal grate will only be a couple of inches off of the bottom of the UDS.
Wyley is offline   Reply With Quote